Diamond Systems EMX-ESG Series Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem I/O Diamond Systems EMX-ESG Series. Diamond Systems EMX-ESG Series 17 halaman. Emx i/o module with 2 gigabit ethernet, 6 serial ports, and 14 gpio

Halaman Cetak

6.6 Ethernet LEDs (J9)

Each Ethernet port has 3 LED signals that may be used to drive indicator LEDS. These signals are available on
an I/O connector. The signals also drive on-board LEDs. LED1 is the link indicator; an LED is connected between
this signal and +3.3VDC. LED2 and LED3 are speed indicators. A bi-color LED may be connected directly across
these two signals. It will display one color for 100Mbps and the second color for 1000Mbps speeds. Alternatively,
a separate LED can be connected between each of these signals and +3.3VDC for a 3 LED display. No external
resistors are needed with these signals.
Connector description: JST ZPD series, SMT right angle; part no. SM10B-ZPDSS-TF

6.7 GPS (U10)

The GPS module connector is a 2x4 .1" / 2.54mm pitch female socket. The VCC pin is jumper-selectable between
+3.3V and +5V derived from the EMX connector.
Connector example: Samtec Model no. SLW-104-01-G-D
EMX-ESG User Manual Rev A.1
P1LED1
2
1
P2LED1
P1LED2
4
3
P2LED2
P1LED3
6
5
P2LED3
+3.3VSB
8
7
+3.3VSB
10
9
NC
NC
GND
2
1
NC
1PPS
4
3
NC
RXDB
6
5
TXDB
3V BAT
8
7
+3.3V
www.diamondsystems.com
Page 13