Diamond Tech DL 5000 Panduan Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Melihat Diamond Tech DL 5000. Diamond Tech DL 5000 8 halaman. Diamond laser band saw
Halaman CetakDL5000 INSTRUCTION MANUAL
-
PAge 5
Quick Tips
1) When cutting, the highest blade speed will usually result in efficient and smooth cutting. Use a
slower speed when working with delicate materials or making very tight turning radius.
2) Do not force materials into the blade. ease the materials into the blade, turning as you go to
create your pattern. Keep a constant forward movement of the material through the blade as you
make your curves. avoid twisting the blade on tight curves.
3) To back out of a cut, turn the saw off and ease the material away from the blade.
4) clean band saw after each use with water. run clean water through pump until it runs clear and
the water tube appears clean. Frequent use of wD40 or similar lubricant on all screws and moving
parts is recommended.
5) when not in use, loosen blade wheel tension. when storing for extended periods, remove
blade and drive belt, then store.
6) Use a waterproof pen to mark your pattern on material. For added protection, use Chap
stick™ or candle wax over line before cutting.
7) Two or more pieces may be cut at the same time by stacking them together and using "tacky
wax", rubber cement or double-sided tape to hold material in place. if using glue or tape, clean
blade after use by running a clean piece of glass or tile through blade. it is not recommended
that you cut through thickness greater than 3/4".