Diamond Tech Power Max II Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penggiling Diamond Tech Power Max II. Diamond Tech Power Max II 6 halaman. Diamond tech power max ii glass grinder operations manual
Halaman Cetak
Troubleshooting
Problem: Grinder bit has become stuck onto the motor shaft
Solution 1: Loosen set screws and push the bit as far down the shaft as possible. Most often the
shaft above where the bit was mounted crusts with glass debris, coolant, hard water residue, etc.
Using a small piece of fine steel wool or scrubby, polish the end of the shaft all the way down to
where the bit rests.
Solution 2: If you can push the bit down as above, but you notice that there is a burr or scar on the
round side of the motor shaft caused by the set screw in the wrong position (it appears as a small
ring cut into the shaft), you will need to polish it out. This can often be done by using the same steel
wool mentioned above, but occasionally it requires stronger abrasives. Be very careful here! You
only want to remove the scar, you do not want to make the shaft smaller. It may be necessary to
use very fine grit emery cloth or sandpaper here. But again, be very careful, the motor shaft can
be easily damaged. Once the scar is polished out, remove the bit. Clean both the bit and shaft and
use lubricant. Never tighten the bit to the round side of the motor shaft.
Solution 3: If the bit is still stuck, use a plumbers helper or vice grip to remove the bit. If further
assistance is necessary, call Diamond Tech toll free at (800) 937-9593 for tech support or to obtain
a Return Authorization Number and further instructions to send your machine in for repair.
Additional Parts and Accessories
ITEM
WORK SURFACE GRID
UNIVERSAL FACE SHIELD
EASY-ON
FOOT SWITCH
™
MAX SPLASH GUARD
GRINDER MOTOR 110V/220V
GRINDER CAPACITOR 110V/220V
SUPER SPONGE REPLACEMENTS
1/4" FAST BIT
1/4" STANDARD BIT
3/4" FAST BIT
3/4" STANDARD BIT
1" FAST BIT
1" STANDARD BIT
ANGLED BIT
REDUCING BIT
1" WORK SURFACE ADAPTOR
3/4" WORK SURFACE ADAPTOR
EASY-GLIDE
WORK SURFACE
™
RUBBER DRAIN STOPPER
PAGE 5 -
ITEM NUMBER
289
DM0750
FS0420
P203
P216/P216A
P221/P221A
66SUPER
GH0230
GH0600
GH0360
GH0350
GH0290
GH0410
GH0300
GH0310
P404
P224
P402
P228