Panasonic PT-DZ6700E Panduan Petunjuk Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Proyektor Panasonic PT-DZ6700E. Panasonic PT-DZ6700E 42 halaman. Brochure
Juga untuk Panasonic PT-DZ6700E: Brosur & Spesifikasi (6 halaman), Brosur & Spesifikasi (6 halaman)

Halaman Cetak
Panasonic PT-DZ6700E Panduan Petunjuk Pengoperasian
Precautions with regard to safety
Do not set up the projector in a high temperature
environment, such as near a heater or in direct
sunlight.
 Failure to observe this may result in fire, malfunction
or plastic deterioration.
Do not set up the projector outdoors.
 The projector is designed for indoor use only.
When disconnecting the mains lead, hold the plug,
not the lead.
 If the mains lead itself is pulled, the lead will become
damaged, and fire, short-circuits or serious electric
shocks may result.
Always disconnect all cables before moving the
projector.
 Moving the projector with cables still attached can
damage the cables, which could cause fire or electric
shocks to occur.
Do not place any heavy objects on top of the
projector.
 Failure to observe this may cause the projector to
become unbalanced and fall, which could result in
damage or injury.
Do not short-circuit, heat or disassemble the
batteries or place them into water or fire.
 Failure to observe this may cause the batteries to
overheat, leak, explode or catch fire, and burns or
other injury may result.
When inserting the batteries, make sure the
polarities (+ and -) are correct.
 If the batteries are inserted incorrectly, they may
explode or leak, and fire, injury or contamination of
the battery compartment and surrounding area may
result.
Use only the specified batteries.
 If incorrect or different kind of batteries are used, they
may explode or leak, and fire, injury or contamination
of the battery compartment and surrounding area
may result.
Do not mix old and new batteries.
 If the batteries are used mixing old and new, they
may explode or leak, and fire, injury or contamination
of the battery compartment and surrounding area
may result.
Remove the used batteries from the remote control
promptly.
 If you leave used batteries in the remote control for
an extended period of time, it may cause liquid
leaking, abnormal internal temperature rising or
explosion.
E
NGLISH - 8
If not using the projector for an extended period of
time, disconnect the mains plug from the mains
socket and remove the batteries from the remote
control.
 If dust builds up on the mains plug, the resulting
humidity may damage the insulation, which could
result in fire.
 Keeping or leaving the remote control with batteries
inside may cause insulation deterioration, electrical
leakage or explosion which could result in fire.
Do not use the old lamp unit.
 The lamp section may break.
Do not put your weight on this projector.
 You could fall or the projector could break, and injury
may result.
 Be especially careful not to let young children stand
or sit on the projector.
Disconnect the mains plug from the mains socket as
a safety precaution before carrying out any cleaning.
 Electric shocks can result if this is not done.
If the lamp has broken, ventilate the room
immediately. Do not touch or bring your face close
to the broken pieces.
 Failure to observe this may cause the user to absorb
the gas which was released when the lamp broke and
which contains nearly the same amount of mercury
as fluorescent lamps, and the broken pieces may
cause injury.
 If you believe that you have absorbed the gas or that
the gas has got into your eyes or mouth, seek
medical advice immediately.
 Ask your dealer about the replacement of the lamp
unit and check the inside of the projector.
Ask an Authorised Service Centre to clean inside the
projector at least once a year.
 If dust is left to build up inside the projector without
being cleaned out, it can result in fire or problems
with operation.
 It is a good idea to clean the inside of the projector
before the season for humid weather arrives. Ask
your nearest Authorised Service Centre to clean the
projector when required. Please discuss with the
Authorised Service Centre regarding cleaning costs.
Do not use chemical treated wipes when cleaning.
 Using chemical treated wipes may result in plastic
distortion or deterioration.