Diamond Traffic Products TTC-4420 Manual - Halaman 11
Jelajahi secara online atau unduh pdf Manual untuk Penghitung Uang Tunai Diamond Traffic Products TTC-4420. Diamond Traffic Products TTC-4420 14 halaman. Trail counter
Halaman CetakNOTE: The "0" on the top line is the total number of activations since you
last started the counter collecting, or since it was powered on. The "Stop!" is
the current hour total and says "Stop!" because the counter is not collecting
data yet and storing it in memory. The "no" is the beam alignment indicator.
("no" means not in alignment). This changes to "AL" when beam is aligned.
You will see this flicker between "AL" and "no" as people cross the beam.
You should be aware of the following:
Activate reset to start a new data collection (see QUICK SETUP
below)
Activate Display to go back and redisplay data stored in memory (if
any). See MEMORY STATUS above.
NOTES: The "Total" value will continue to count, even if data collection is
stopped.
You can toggle on/off the sonalert by holding a magnet on Display and
activating Reset with a second magnet before releasing Display. Note that this
is not normally done because during the SETUP step you go through an
alignment procedure with the siren. However, it can sometimes be useful if
you want to hear the Siren without restarting collection. When the Siren is
enabled, an asterisk ("*") appears in the top right corner.
When collecting is active, the "Stop!" changes to the current total count for
the hour. At the beginning of each new hour, this value is reset to zero.
The trail counter continues to count and store data normally even when you
are manually reading out data or connecting a DataHog to the serial port.
Once collection has started, the trail counter can store more than 400 days of
hourly counts. If it fills up its memory, it will automatically stop storing new
counts (but the Total Count continues to update).
You need to know that the trail counter does not know correct time or date.
You must keep a record of time and date you started the trail counter.
If neither Display or Reset is activated for 10 minutes, the screen changes to
the BLANK DISPLAY (see below).
If the voltage into the counter drops below 1.5V (0.75 per battery in 2X2
array), then the right side of the display shows "LOW BAT". The Trail
Counter will turn off its beam and stop accepting new counts, which means
zeros will be written to the memory. When the battery voltage rises above
1.5V, operation will begin again.
P10