3Com 3C16465 - SuperStack II Baseline Switch 24 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih 3Com 3C16465 - SuperStack II Baseline Switch 24. 3Com 3C16465 - SuperStack II Baseline Switch 24 9 halaman. Superstack® ii baseline 10/100 switch 12-port (3c16464) and 24-port (3c16465)
Halaman Cetak
M
OUNTING
Introduction
The Baseline 10/100 Switch is supplied with two mounting brackets
and six screws. These are used for rack mounting and wall mounting
the unit. When mounting the unit, you should take note of the
"Positioning the Baseline 10/100 Switch"
guidelines given in
overleaf.
Rack Mounting the Baseline 10/100 Switch
The Baseline 10/100 Switch is 1.5U high and will fit a standard
19-inch rack.
CAUTION: Disconnect all cables from the Baseline
10/100 Switch before continuing. Remove the self-adhesive
pads from the underside of the unit, if already fitted.
1
Place the unit the right way up on a hard, flat surface with the
front facing towards you.
2
Locate a mounting bracket over the mounting holes on one
side of the unit, as shown in Figure 1 below.
3
Insert the three screws and fully tighten with a suitable
screwdriver.
4
Repeat the two previous steps for the other side of the unit.
5
Insert the unit into the 19-inch rack and secure with suitable
screws (not provided).
6
Reconnect all cables.
K
I
IT
NSTRUCTIONS
5
Wall Mounting the Baseline 10/100 Switch
CAUTION: Disconnect all cables from the Baseline
10/100 Switch before continuing. Remove the self-adhesive
pads from the underside of the unit, if already fitted.
1
Place the Baseline 10/100 Switch the right way up on a hard,
flat surface with the front facing towards you.
2
Locate a mounting bracket over the mounting holes on one
side of the unit, as shown in Figure 2 below.
3
Insert the two screws and fully tighten with a screwdriver.
4
Repeat the last two steps for the other side of the unit.
5
Ensure that the wall you are going to use is smooth, flat, dry
and sturdy. Attach a piece of plywood, about 30cm x 50cm x
1.5cm (12in. x 20in. x 0.5in.) in size, securely to the wall if
necessary, and mount the Baseline 10/100 Switch as follows:
a
Position the unit against the wall (or plywood) ensuring that
the ventilation holes face sideways. Mark on the wall the
position of the screw holes for both wall brackets. Drill the
four holes.
b
Using suitable fixings and screws (not provided), attach the
unit securely to the wall (or plywood).
c
Reconnect all cables.