Panasonic RX-ES27 Panduan Petunjuk Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Panasonic RX-ES27. Panasonic RX-ES27 22 halaman. Portable stereo cd system
Juga untuk Panasonic RX-ES27: Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (40 halaman)

Halaman Cetak
Panasonic RX-ES27 Panduan Petunjuk Pengoperasian
7
3
A
7
1
7
2
7
3
7
B
7
7
2
3
•
7
1
TUNER
7
2
AUTO SCAN
7
3
AUTO SCAN
7
C
FM MODE/BP
FM MODE/BP
PRESET EQ
S.VIRTUALIZER
AUTO SCAN
7
D
FM
8
RQT6274
RQT6274-C (4-8)En3
7
7
1
2
7
PRESET EQ
TAPE
TUNER
CD
1
S.VIRTUALIZER
REW
FF
AUTO SCAN
PRESET TUNE
CD SKIP
–
VOLUME
+
Indicates auto scan
C RESET
RANDOM
REPEAT
TAPE
TUNER
CD
REW
FF
PRESET TUNE
CD SKIP
VOLUME
AM
8

The Radio

Preparation: (when using batteries) Press [
A

Normal tuning

Press [TUNER BAND] to select "FM" or "AM".
1
(Unit comes on when using AC power.)
Each time you press the button:
AM
FM
Q ] or [ R
Q
Q
Q
Press [ REW/–/Q
2
station.
"
" is displayed during FM stereo broadcasts.
Press [+, – VOLUME] to adjust the volume.
3
B

Using auto scan

Remote control only
You can search for a station by listening to all tuned-in stations for 8
seconds each.
Press [TUNER] to select "FM" or "AM".
1
Press [AUTO SCAN].
2
Auto scan starts.
Press [AUTO SCAN] when you find the desired
3
station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
C
If noise is excessive in FM
Remote control only
Press [FM MODE/BP] to display "
Monaural sound is selected ("
" goes off) and noise reduces when
reception is weak.
Press [FM MODE/BP] again to cancel the mode.
Auto-tuning
Press and hold [REW / – / Q] or [R / + / FF] until the frequency
starts changing rapidly.
The frequency stops when it finds a station. (Interference may also
cause it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [REW / – / Q] or [R / + / FF].
D
To improve reception
FM: Change the length and direction of the antenna.
AM: Change the facing of the unit.
Note
• AM reception is briefly interrupted if [0 DECK] is pressed.
• To improve reception when using the unit in a building or vehicle,
use it near a window.
To receive FM broadcasts allocated in 0.1MHz
Main unit only
First press [TUNER BAND] to select "AM". Now, press and hold
[TUNER BAND]. The display changes in a few seconds to show the
current lowest FM frequency. Continue to hold down the button.
The minimum frequency changes and the step is changed at the
same time. Changing the step erases all preset stations.
Repeat the above to change the step back.
12/13/01, 4:04 PM
/ I
POWER
].
R /+/FF ] to select a
R
R
R
".
MONO