Diasend Transmitter Panduan Cepat - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Peralatan Medis Diasend Transmitter. Diasend Transmitter 16 halaman.
Halaman CetakBlood glucose meters – with infrared connection
Set the meter in upload mode by following the instructions below.
Place the glucose meter's top end directed towards the IR eye on
the diasend® Transmitter.
Please make sure to keep the device completely still during the upload.
i
Do not remove the device until the green ok indicator is lit.
Roche Accu-Chek
Aviva Nano
Aviva Plus Black
Aviva Plus Silver
Nano
Performa
Performa Nano
Aviva Combo
Aviva Expert
Accu-Chek Aviva Solo
Insight
Compact Plus
IR connection – No cable needed
IR connection – No cable needed
Smart Pix 2 cable
Note! Connect the Insight handset/glucose meter
with a micro USB cable to the Smart Pix 2.
IR connection – No cable needed
IR
IR eye on Transmitter
Activate IR transmission by pressing and holding
the two arrow buttons until two arrows appear tin the
display.
In the main menu, go to My data and
select Data transfer.
1. Connect the Smart Pix 2 cable to the Transmitter
and wait for the blue indicator on the Smart Pix 2
to start flashing slowly.
2. Connect the Insight handset to
the Smart Pix 2 with a micro USB cable.
3. In the handset menu select Connect to PC and
press OK.
4. Ensure that the pump is within reach of the Insight
handset.
5. The blue indicator on the Smart Pix 2 is on while
the data is being transmitted from the device to
the Smart Pix 2.
6. The blue indicator turns itself off and both
Smart Pix 2 and device emit a sound to signal that
the data is being transmitted from the
Smart Pix 2 to the Transmitter. Do not disconnect
the Smart Pix 2 yet!
7. Wait for the Transmitter to signal the upload was
successful (green ok indicator has a steady light).
Activate IR transmission by pressing and holding
the buttons S and M below the display until two arrows
appear in the display.
12