Axis 205 Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kamera Keamanan Axis 205. Axis 205 10 halaman. Axis communications network camera
Juga untuk Axis 205: Panduan Instalasi Cepat (6 halaman), Spesifikasi (Italia) (2 halaman)

Halaman Cetak

Troubleshooting

Symptoms

Poor quality images.

No images in browser.

Broad vertical white lines

appear across the image.

Note:

If you still have a problem after reading this information, please contact your reseller, or visit the

Axis Support Web at www.axis.com/techsup/

Pinging Your IP Address

By sending a packet to the specified address and waiting for a reply, the Ping utility can

determine whether a specific IP-address is accessible or if there is a conflict.

Follow the instructions below to use Ping to troubleshoot TCP/IP problems on your

network:

1. Start a Command prompt and type

used to install the camera.

2. If you receive the reply

accessible on your subnet. The unit must be reinstalled, using an unoccupied IP

address that is valid for use on the same subnet as the workstation from which you are

attempting to perform the installation. Please consult your network administrator.

If this does not solve the problem, disconnect the camera from the network and run Ping

again. See the table below for an interpretation of the results.

Ping Reply

Reply from <IP address>: bytes=32 time<10 ms TTL=64

Request timed out

Note:

To start a Windows Command Prompt (also known as a DOS prompt), click the Start button, then

click Run and then type cmd.

AXIS 205 Network Camera Installation Guide

Part no: 20862

Revision 1.0

Dated: September 2003

Possible causes

Display properties incorrectly

configured for desktop.

ActiveX disabled.

Too much light. This can

happen e.g. with sunlight

reflexes.

ping x.x.x.x

destination host unreachable,

AXIS 205 Network Camera

Remedial actions

Open the Display Properties in your desktop and configure your

display to show at least 16-bit color.

In Microsoft Internet Explorer, ensure that ActiveX has not been

disabled in the Internet Options menu.

Exposure to sunlight or strong halogen light will cause serious

damage to the CMOS sensor. Reposition your camera in a more

shaded location.

Note: damage caused to the AXIS 205 by exposure to direct

sunlight or halogen light is not covered by the product warranty.

, where

Interpretation and recommendation

This IP address is already in use and cannot be used again. Please

obtain a new IP address.

This IP address is not used and is available for use with your Axis

camera. If you already installed the unit using this IP address, the

installation may have failed. Reinstall the unit. Also check all cabling.

is the IP address

x.x.x.x

then the camera is not