Axis Axis 211 Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera Keamanan Axis Axis 211. Axis Axis 211 16 halaman. For somat edaq; somat edaq lite; axis m7001 video encoder; korenix jetnet poe switch
Juga untuk Axis Axis 211: Spesifikasi (6 halaman), Brosur & Spesifikasi (4 halaman), Brosur (2 halaman), Spesifikasi (2 halaman), Panduan Instalasi Cepat (8 halaman)

Halaman Cetak
Axis Axis 211 Panduan Memulai Cepat

1 Getting Started

A3090-1.1 en
1.1

Overview

This manual provides instructions on using the Axis network cameras with HBM's
lite data acquisition system. For more detailed information on using
eDAQ or eDAQ
lite or TCE software, refer to the eDAQ or eDAQ lite User Manual.
the eDAQ, eDAQ
The TCE software supports the following devices:
Device
Axis 211 Network Camera
Axis M7001 Video Encoder
Axis P1311 Network Camera
Axis P1344 HD Network Camera
Korenix JetNet POE Switch with HBM POE PSU
NOTE
HBM only supports the devices listed in the above table and assumes no risk if any
other devices are used.
1.1.1

Equipment

To use an Axis network camera to record and view video, the following equipment is
required:
• a networked eDAQ or eDAQ
• a power over ethernet (POE) switch (HBM recommends the Korenix JetNet)
• a support PC with a JavaScript-enabled web browser
• a TCP/IP network (DHCP recommended)
• Test Control Environment (TCE) (see previous section for compatible versions)
• InField version 2.4.0 or later
1.2

Step 1: Set Up the Network Camera

1.2.1

Reset the Camera to Factory Default

First, reset the camera to factory defaults:
1. Remove power from the camera.
2. Press and hold the control button and reapply power to the camera from the POE
port on the switch.
3. After the amber status indicator turns amber, release the control button.
4. Wait for the status indicator to turn green, which indicates that the camera has been
reset. This may take up to two minutes.
NOTE
The location of the control button and status indicator depends on the camera model.
For information on specific models, refer to the Axis documentation.
Network Camera Devices
Compatible TCE Version
TCE 3.14 or later
TCE 3.15 or later
TCE 3.15 or later
TCE 3.15 or later
TCE 3.15 or later
lite with firmware version 3.14 or later
9