EasyPro EP200 Petunjuk Pengoperasian, Keselamatan, Garansi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian, Keselamatan, Garansi untuk Pompa Air EasyPro EP200. EasyPro EP200 4 halaman. Mag drive pumps
Halaman Cetak
8.
Do not remove the pre-fi lter or the pre-fi lter cover from the pump as this will cause excess de-
bris to enter the pump and may void the warranty.
Troubleshooting:
If the pump fails to operate, please check the following before contacting EasyPro:
Note: Always disconnect from electrical outlet before handling the pump.
1.
Check the GFCI circuit breaker or try another GFCI electrical outlet to ensure the pump is get-
ting power.
2.
Check the tubing for kinks and obstructions. Check fi lter cover and foam fi lter for blockage.
Follow cleaning steps in the maintenance section if blockage is suspected.
3.
If necessary, remove and clean the impeller assembly.
Service & Maintenance
1.
Disconnect all power supplies before service.
2.
It is highly recommended to place the pump in either an EasyPro skimmer or into an EasyPro
pump protector.
3.
Clean the intake screen and foam fi lter
when the fl ow is visibly reduced.
4.
Clean the pump and impeller with clean
fresh water.
5.
When cleaning the pump and impeller,
be careful not to loose the small plastic
washers positioned at the top and bot-
tom of the impeller. These washers are
critical to the quiet and effi cient opera-
tion of the pump.
6.
Check inside the impeller housing for
large debris or algae that could reduce
the fl ow.
7.
Clean the impeller housing using cotton
swabs. Clean the outside of the impeller
with a damp cloth and clean water.
Foaming
Jet
Volcano
Fountain Nozzles
Double Volcano
Waterbell
Complete Set
2
Diverter Valve