EasyPro ETP10N Petunjuk Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Pompa Air EasyPro ETP10N. EasyPro ETP10N 4 halaman. Submersible trash pump

Caution

• Do not allow dry operation

• Do not allow foreign objects to enter intake

• In case of power outage, turn off power switch to avoid damage when power

resumes

• If excessive vibration occurs turn off power immediately

Protection System

The motor has a built in protection system which stops the pump when overheating

occurs, due to excessive load. Load could be caused by clogging at inlet or outlet

and when a fluctuation in the power supply occurs.

Water Level

• Never operate below minimum water level which is 6" above base level (about half

way submerged)

• Continuous operation water level is at least 14" above base level (submerged)

• Operate for a maximum of thirty minutes if water level is between 6" and 14"

Inspection

• Always turn off power and remove power outlet plug from power outlet before

performing inspection

• Check regularly for drop in performance and remove any clogged material from

inlet area, outlet hose and pipe

• Check and tighten nuts and bolts if required

• Check with dealer for advice on other repairs

Pump Storage

• When the pump is out of use for an extended period - wash it, dry it and store

indoors

• Do not leave pump outdoors in freezing conditions

• If the pump is left in water but not operating regularly, test run it at least once a

week

Disassembly and Reassembly

• Do not attempt to disassemble pump during warranty period

• If impeller replacement is required, contact dealer for service