HTC 650 HDX Manual - Halaman 33

Jelajahi secara online atau unduh pdf Manual untuk Mesin Lantai HTC 650 HDX. HTC 650 HDX 40 halaman.
Juga untuk HTC 650 HDX: Panduan Pengguna (48 halaman)

Halaman Cetak

HTC 650 HDX

6.2.2

Resetting the frequency converter

•

Press and hold the "RESET" button in for two seconds.

6.2.3

Checking the last error code

Press FUNC, D01 is shown in the display.

Press "arrow up", until D08 is shown in the display.

Press FUNC, the error code is shown in the display.

Press FUNC again, the current frequency is shown in the display.

Press FUNC once again, the motor voltage is shown in the display.

Press FUNC once again, the voltage of the DC bus is shown in the display.

Press "arrow up", until D09 is shown in the display, in order to see the previous error

codes.

6.3

Omron

6.3.1

MX2

Error

Cause

code

E01

Excess current at constant

speed

E02

Excess current during

deceleration

E03

Excess current during

acceleration

E04

Excess current under other

conditions

E05

Overload

E08

Internal EEPROM error due to

overheating or interference

E09

Under-voltage

E10

Internal current supply error

E11

Internal processor fault

3.0

Action

The machine is running too fast or with too great a load. Lower

the speed, lower the load by changing the position of the

weights and check your tools. Check mechanical inertia, spin

the grinding discs.

See E01

Open the control cabinet and ventilate. Check the filter and the

cooling fans in the cabinet. Let the frequency converter cool

down before restarting.

The connection cable is too long, poor connection or too many

consumers connected to the mains. Change socket, use shorter

cables and lower the speed.

Contact HTC Service Centre.

Reset the electronics using the Reset procedure.

Electronic error codes