EasyPro LA5W Petunjuk Pengoperasian, Keselamatan, Garansi - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian, Keselamatan, Garansi untuk Peralatan Rumput dan Taman EasyPro LA5W. EasyPro LA5W 4 halaman. Koi and ornamental pond aeration kit
Halaman Cetak
Winter Operation and Deeper Ponds
If fish are present in the pond, place the diffuser between the shallowest and deepest portion of your
pond. For instance, if the deepest part of your pond is 6' and the shallowest is 1', place diffuser in
the 2' - 3' range for wintertime operation. This will prevent the water at the deepest portion from
being mixed with colder water.
Maintenance
1.
Always unplug unit before service, cleaning or any maintenance.
2.
Over time the compressors may need to have the diaphragm or piston replaced. See chart
below for compressor repair kits.
Troubleshooting
Loss of air output but unit is running:
•
Check to make sure the air filter has not been blocked or clogged by dust.
•
Check to make sure lines are not kinked or plugged. If used in winter time, line may have ice in
the line. A small amount of rubbing alcohol can be run down the air line to thaw the ice.
•
Inspect the diffusers to ensure they are clean. Replace or clean as necessary. See chart below
for replacement diffusers.
•
Inspect diaphragms/pistons. Replace as necessary.
•
Also see compressor manual for more troubleshooting details.
Koi and Ornamental Pond Aeration Kit Components:
Kit
Part # Compressor
LA1
KLC25
LA2
KLC40
LA3
KLC60
LA4
KLC80
LA5W
ML28
LA10W
ML45
LA15W
ML80
Caution:
•
During operation, do not touch the lower housing with bare hands as the temperature will
become about 70ºC (158ºF). (Temperature will not affect the performance of the pump.) Thermal
overload will turn off the compressor when temperature gets too high. Unit will come back on
after it cools down. Causes for excess heat should be determined and eliminated. Common
causes include lack of ventilation and excess back pressure in the system. Remedies for these
causes should be found to avoid over heating of the units.
•
Proper sizing and selection of tubing, length of tubing, number of diffusers and depth of
diffusers are all important factors for maximizing performance. These units are designed to
produce fairly large volumes of air at low pressure. Extra back pressure created by restrictive
tubing, undersized or clogged diffusers, incorrect valve systems or deeper water can cause
excess wear and tear on the rubber diaphragms. While replacing the diaphragms is easy to do,
too much back pressure may require more frequent repair.
Tubing
25' Quick Sink
50' Quick Sink
75' Quick Sink
100' Quick Sink
15' Quick Sink
15' Quick Sink
15' Quick Sink
Diffusers
(1) 8" Rubber
(RAD8)
(2) 8" Rubber
(RAD8)
(3) 8" Rubber
(RAD8)
(4) 8" Rubber
(RAD8)
6" Rubber
(RAD6)
12" Rubber
(RAD12)
2 - 12" Rubber
(RAD1250)
Compressor
Repair Kits
KLC25DK
KLC40DK
KLC68DK
KLC68DK
ML28RK
ML45RK
ML80RK