EasyPro EC1300 Petunjuk Pengoperasian, Keselamatan, Garansi - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian, Keselamatan, Garansi untuk Sistem Penyaringan Air EasyPro EC1300. EasyPro EC1300 8 halaman. Eco-clear pressurized filters

Halaman Cetak

Cleaning or Replacing the Filter Pads.

When installed on a dirty pond, the foam pads will need to be cleaned more frequently

until the pond clears. As pond conditions stabilize, the time between cleanings will

increase. Pads are meant to be slightly dirty, there is no need to overclean them. If you

notice a decrease in water flow, the filter may need to be cleaned. Also, be sure to check

that the pump is not clogged. Replacing the pads should be done as they begin to show

signs of wear to maximize filtration capabilities.

1. For EC1300U with UV, be sure to turn this off or

unplug it before servicing. Unplug the pump before

opening filter.

2. Loosen the locking nuts that secure the tubing

connectors to the filter and remove them from the

lid. Be sure not to lose the gaskets that seal the

connectors to the filter.

3. To access the pads and bio-balls for cleaning or

replacement, the top of the filter can be removed by

taking off the clamp. Start by sliding the locking wedge

to release tension.

4. T o remove the clamp completely depress the tab and

open the clamp wide enough to remove from the filter.

5. Carefully lift the lid off the tub. Be sure to not lose the

O-Ring that seals the lid and tub.

6. Filter pads can be removed and rinsed with clean water.

Replace with new pads if they are showing signs of

wear.

7. Bio-balls can be accessed by removing the plate at the

bottom. Bio-balls can be rinsed with pond water to get

larger debris from them, but do not overclean these. This

is where the beneficial bacteria grow.

8. Replace items in reverse order and install the O-ring with

lid assembly back on filter body.

9. Secure the clamp around the filter by closing the clamp

firmly and sliding locking wedge into place for a tight

seal.

10. Reattach hose connections with gaskets and locking

nuts securely in place.

11. Plug in pump and UV. Observe the filter and check for

leaks.

Step 3

Step 4

Step 6