EasyPro ECF10U Petunjuk Untuk Manual Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Untuk Manual Pengoperasian untuk Sistem Penyaringan Air EasyPro ECF10U. EasyPro ECF10U 8 halaman. Dual filtration, high quality pressurized filters

Halaman Cetak

8. Use a clean cloth to

remove the UV light by

gently pulling up on the

UV bulb. (see figure 7)

9. Do not touch the bulb

with your fingers.

10. Carefully remove the

black protector on the

end of the bulb. Install

the black protector on

the end of the new UV

light bulb. (see figure 8)

11. Carefully install the new

UV bulb in the base, be sure to use a clean cloth to install

the new bulb. Press the bulb firmly into the base until you

here a click. (see figure 7)

12. Carefully slide the new bulb into the sleeve and screw the

cap into place.

13. Reattach the cord retainer clip with the two screws.

14. If you have an ECF25U or an ECF40U set the UV cover

back on top of the pressure filter and tighten the three

screws.

15. If you have an ECF10U make sure to line up the power

cord in the back with the slot in the UV cover. Be sure to

line up the two slots in the front of the UV cover with the

two prongs behind the discharge connection. Push down

on the UV cover and line up the arrow on the UV cover with

the arrow on the retaining ring. (see figure 9)

16. Twist the UV housing back to desired position and tighten

the screws down on the retaining ring.

UV Sleeve Replacement and Cleaning

1. Make sure the unit is disconnected from the power source.

2. Unscrew the barbed fittings from the inlet and outlet on the

filter.

3. Loosen the screws on the top retaining ring. Remove the

screws. The retaining ring should now be loose. (see figure

4. Remove the UV cover and set aside. (see figure 3)

5. Remove the two screws and the plastic retainer clip that

hold the cord in place and set aside. (see figure 5)

6. Unscrew the UV light and carefully remove from the hous-

ing. (see figure 10)

7. Carefully set the UV bulb aside, being careful not to touch

the UV bulb.

Figure 7

Figure 8

Figure 9

Figure 10

Figure 11