EasyPro AquaShine RGB3 Petunjuk Pengoperasian, Keselamatan, Garansi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian, Keselamatan, Garansi untuk Peralatan Pencahayaan EasyPro AquaShine RGB3. EasyPro AquaShine RGB3 8 halaman.

Halaman Cetak

LED Light Kit Assembly Instructions for 1/2 and 1 hp Aqua Fountains

Actual light fixture appearance may vary slightly from figures below.

1. Attach the light fixture to the supplied brackets. The nylock nut

comes attached to the bracket for shipping. You will need to

remove nylock nut and install the yoke of the light fixture to the

bracket. Run the pig tail as shown in Figure 1. Secure the light

fixture with nylock nut.

2. Remove float cover from top of fountain. Float cover is not

secured to float and can simply be lifted off.

3. The float will have three pre-drilled holes for the light brackets.

These are marked with "LT" next to them as shown in Figure 2.

Bolt the lights, using LKH-AFBW hardware, onto the float and

tighten securely. Place the large washer on the top of the float

and run the bolt through the float.

4. To secure the light bracket to the float, line up the hole closest

to the end with the bolt. Secure bracket to bottom side of float

using nylock nut and tighten. Don't overtighten otherwise the

upper washer may pull too far into the float. Some movement

of the bracket will not affect quality of lighting. For two light kits

swivel the light brackets to widest position possible.

5. Connect pigtails to cord splitter (two or three x 1 depending

on kit). Be sure the pigtails go around the motor screen in an

orderly way so all lights can be connected without twisting.

Verify the o-ring is present in the female portion of the

connectors. (Figure 3) Push pigtails into splitter and secure

with 1/2 turn quick connect nut on splitter. (Figure 4)

6. Connect main cord to the remaining end of the splitter section.

Be sure the o-ring is present (Figure 3) and secure cords with

1/2 turn quick connect nut. (Figure 4) Multiple cords can be

connected up to 300' long between the light fixtures and the

control unit.

7. The main cord MUST BE SECURED to the eye bolt of the

fountain. Use the plastic cable ties included in your kit to do

this. This acts as a strain relief for the cords.

8. Adjust the angle of the light fixtures based on the spray pattern

being used. Tip in toward center for narrower pattern and tip out slightly for wider pattern.

9. Plug the main cable into the pigtail of the mounted controller unit. Be sure to mount the

weatherproof controller with timer in a secure location near a power supply and plug into 115 volt

outlet. See "Setting the Timer" for detailed instructions on the controller.

10. Over time the LED lights may appear dimmer than when new. This is caused by algae or sediment

on light lens. This can easily be removed with a small brush (a toothbrush works great).

Figure 1

Figure 2

o-ring

Figure 3

Figure 4