EasyPro WFL2 Petunjuk Pengoperasian, Keselamatan, Garansi - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian, Keselamatan, Garansi untuk Peralatan Pencahayaan EasyPro WFL2. EasyPro WFL2 8 halaman. Fountain light kit, stainless steel, warm white led light kits, two-light or three-light kits for use on easypro 1/2 and 1 hp aqua fountains or kasco 1/2 to 2 hp vfx, af or jf series fountains

Halaman Cetak
Operation Instructions for Manual Function
1. Be sure the controller is plugged into 110 volt GFCI protected outlet.
2. Remove clear plastic cover from timer. Keep cover safe and replace when finished.
3. Unlock the timer by pressing the "C/R" button four times. This removes the "a" character in
lower left corner of the display screen.
4. Press "Manual" button to select desired function. The ON function will tell controller to send
power to lights and OFF function will stop power from being supplied to lights.
5. When pressing the "Manual" button it will scroll through settings in this order: ON, AUTO,
OFF, AUTO.
Here is what happens at each setting and in this order
ON – Power is supplied to the lights.
AUTO - When using the "Manual" button and stopping on AUTO right after the ON setting,
power to the lights will remain on until next programmed OFF setting.
OFF – Power supply to the lights is turned off.
AUTO – When stopping on AUTO after the OFF setting, power to the lights will be off and
will turn back on at next programmed "On" setting.

Service and Maintenance

1.
Disconnect the transformer from the power supply before service.
2.
All parts of the lighting system should be checked on a regular basis
to make sure the system is functioning properly.
3. All wires should be protected from possible damage from wildlife and other
causes. Damaged wires due to neglect are not covered under warranty.
4. If light output is diminished check the face of the light fixture for debris and
clean if necessary, or use remote control to increase brightness.
5. If lights are not working, be sure the timer on the controller is set to operate
lights when desired.
7