DICE MediaBridge Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Mobil DICE MediaBridge. DICE MediaBridge 7 halaman. Integration solution for honda/acura vehicles
Juga untuk DICE MediaBridge: Panduan Pengguna (2 halaman)

Halaman Cetak
Content Identifier
DICE interface for iPod
Installation Guide/User Manual
user manual
docking
vehicle specific
interface module
About Dip Switch Settings
The configuration switches located on the DICE module are used to set the operation of the interface by the installer.
Incorrect dip switch settings may cause the DICE interface not to work properly or not to operate at all. Disconnect the
vehicle harness from module and cycle ignition off for 50 seconds after changing the switches!
for i-Honda-
R2
Car configuration switches
OFF
OFF
Switches should remain in the default OFF position.
CDC
Default
for i-Honda-
R3/R4
Car configuration switches
Recommended for radios NOT supporting Satellite
OFF
OFF
(XM) or if factory SAT is installed and user wishes to
retain it.
CDC
Default
Recommended for Satellite (XM) capable radios. This
type of emulation provides full text display on the radio.
ON
ON
If Satellite (XM) is equipped it must be disconnected to
SAT
operate flawlessly in this mode.
36
integration for iPod
for i-Honda-
cable
Honda-R2
Bus Connector
kit:
DICE module
Selected emulation
kit:
DICE module
www.diceelectronics.com
R2
R3
kit
for i-Honda-
Honda-R3
Bus Connector
(regular harness that is used
for non-nav Acura and
disables XM (if equipped))
integration for iPod
iPod configuration switches
It is best selected when text display is supported by
OFF
OFF
the radio. After the initialization the iPod will be locked
for increased interface functionality
"Locked"
Default
It is best selected when text display is NOT supported
by the radio. Track numbers and times are not
synchronized between the iPod and radio. Because there
is less data transfer between the iPod and radio, this
ON
ON
"iPod"
mode has the fastest response time. Content is selected
on the iPod only.
iPod configuration switches
This mode should be selected when browsing is
OFF
OFF
preferred from the radio. After connecting the iPod you
will see the DICE logo on the screen. After the initializa-
"Locked"
tion the iPod will be locked for an increased interface
Default
functionality.
This mode should be selected when controls on the
iPod are preferred. The radio can display the track name
ON
ON
but has limited browsing capabilities.
"Display"
This mode is ideal on radio with single line display.
In "Smart" mode, both "Locked" mode or "Display" mode
OFF
can be selected by the user from the iPod when
ON
connected.
"Smart"
1-888-342-3999
R4
kit
for i-Honda-
Honda-R4
Bus Connector
(Y-harness required for
navigation-equipped Acura or to
retain factory XM)
Selected emulation
Selected emulation
kit