Dickinson 00-NEW-P9000 Panduan Instalasi dan Pengoperasian - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Perapian Dalam Ruangan Dickinson 00-NEW-P9000. Dickinson 00-NEW-P9000 15 halaman. Propane fireplace/heater
Juga untuk Dickinson 00-NEW-P9000: Panduan Instalasi dan Pengoperasian (12 halaman)

Halaman Cetak

Additional Accessories

19-000
19-005
19-151
19-150
19-100-10
19-100-20
01-031
01-074
01-073
19-030
19-080
02-014
Thermocouple and Orifice Cleaning Instructions
1. To replace the thermocouple or cleaning the orifice on the heater the front cover must
be removed. Remove the brass knobs with a 5/64 Allen wrench along with the nuts
holding the black plates.
2. Next remove all the screws on the sides of the heater (careful- hold on to the front
cover and remove the top and bottom). Open the door wide and pull back slightly from
the front cover to remove the 2 connectors on the rocker switch (use needle nose pliers).
3. Using a 5/16 wrench disconnect the brass nut at one end of the thermocouple, located
on the back of the control valve. The other end of the thermocouple is located on the front
just below the door opening and a little to the left. Remove the 2 Robertson socket screws
and take out the old thermocouple.
4. Connect the new thermocouple to the little bracket and re install it to the front panel
making sure the thermocouple is in as deep as it can be mounted to insure the flame will
burn close enough to the tip. Install other end into the back of the valve. This is not a part
of the propane system so no need to worry about leaks.
5. To clean the orifice, remove the copper fuel line at the front of the heater just below
the door opening, then loosen the lock nut and remove the brass fitting from the heater.
The orifice is located in the brass fitting. Clean the hole with a wire smaller than a paper
clip or try compressed air. Assemble in reverse order. Use locktite or similar on the brass
fittings for vibration purposes.
-12-
28
inch
(70cm)
(approx.)including coupling
10
inch
(25.4cm)
(approx.)including coupling
Low pressure regulator only
Low pressure regulator and mounting kit
(For use when there is no onboard propane system - for use
with propane bottles)
10ft (3 m) CGA/AGA propane hose
20ft (6 m) CGA/AGA propane hose
Fan
Control for fan
On and off switch
Stainless steel flue guard
Double exhaust cap guard
Thermocouple
Direct
Vent
Pipe
Direct
Vent
Pipe
Extension
Kit
Extension
Kit