Dickinson Propane 2Burner Drop-in Cooker Panduan Penggunaan dan Perawatan Instalasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan Instalasi untuk Peralatan Dapur Dickinson Propane 2Burner Drop-in Cooker. Dickinson Propane 2Burner Drop-in Cooker 15 halaman.

Halaman Cetak

Installing when you have access under the countertop.

• Ensure the cut out dimensions. A small bead of sealant is recommended for a good seal.

• Install the four metal angle brackets into the tie down flanges that are on the side of the

housing. The flanges should be inserted so the bracket slides DOWN into the flange slot

and the threaded hole is facing the countertop and not the housing.

• Thread the four stainless steel machine screws into the brackets. The ends of the screws

will contact the countertop. Depending on the thickness of your counter material you may

need a wooden spacer at the points where each of the four mounting screws go.

Stop turning when all four corners are tight.

• These brackets will prevent the appliance from becoming unseated due to vibrations or

the motion of the boat.

Installing when you do not have access under the countertop.

• It may occur that you do not have access to the underside of the countertop where the

Cooktop is to be installed. If this is the case, locate the four 'knock out slugs' on the

inside of the appliance housing. They are small and on the side walls about 2.25" above

the bottom of the inside of the cooker.

• Punch out or work out the slugs so you are left with four clear holes.

• Follow the instructions indicated above on cut out dimensions and sealant.

• Place the appliance into the cut out. Use four stainless sheet metal screws in the 'knock

out holes' to secure the appliance to the countertop material.

• If the countertop material is especially thin, drill out guide holes before driving in the

screws.

• These screws will prevent the appliance from becoming unseated due to vibrations or the

motion of the boat

OPERATION

LIGHTING THE BURNERS

WARNING :

BEFORE LIGHTING BURNERS REMOVE ALL FLAMMABLE MATERIALS E.G.

CURTAINS, TOWELS ETC. FROM THE IMMEDIATE VICINITY.

INSTALLATION