Dickson KT856 Memulai - Halaman 6

Jelajahi secara online atau unduh pdf Memulai untuk Perekam Suara Dickson KT856. Dickson KT856 8 halaman. Remote sensing temperature recorder

Halaman Cetak

8. Each time P P P P en

en H H H H ome

recently adjusted position) until On/Off

Note: Pressing the On/Off button will exit the adjustment and return the unit to normal operation.

Each time the Pen Home or On/Off button is pressed, the adjustment currently in progress will be

stored. The unit will take one minute to exit Pen Adjust Mode once the On/Off button is pressed.

CALIBRATION

KT8P0/2/3:

The R400 Replaceable Sensor was carefully tested and calibrated before being shipped

from the factory. For greatest accuracy, we recommend replacing the sensor every 6-12

months (does not include N400 and N450).

To order a Calibrated Replacement Sensor Call customer service at (630) 543-3747 or go

to www.dicksondata.com.

When your new Replaceable Sensor arrives, simply turn off the recorder, remove and

discard the old sensor, plug in the new one and power the recorder back on. Your

recorder will continue to record temperature and humidity without interruption.

KT856:

The KT856 was carefully tested and calibrated before being shipped from the factory. For

greatest accuracy, we recommend factory re-calibration every 6-12 months. Call

customer service at (630) 543.3747.

USER CALIBRATION

If you have an accurate standard to compare against, the Replaceable Sensor or unit (KT856)

calibration can be adjusted at one point. This will not adjust the span and is not as accurate as

replacing the Replaceable Sensor with a newly calibrated one, or returning the KT856 for

recalibration.

1. To activate Calibration mode, turn the unit on and press and hold both the On/Off

Adjust

Adjust- - - - Down

Down

Down button until the LED is solid green. The LED will then blink amber at which

point only the pen being adjusted will show on the display.

Note:

Note: Make sure to press the Adjust-Down button first so the unit will not turn off

Note:

2. To raise the unit of measurement, press the Adjust

measurement, press the Adjust

blue pens on a two pen unit and stores the current adjustment value.

3. When Calibration is complete, press the On/Off

even after you turn the unit off or if AC power fails.

Note:

Note: After two hours, if no buttons are pressed, the unit will time out of Calibration mode

and resume normal operation. If you wish to cancel the Calibration, simply enter Calibration

mode and toggle through the steps without adjusting displayed readings. Exit by pressing

the On/Off

On/Off button. You have now restored factory calibration settings.

On/Off

Note:

Note: It is recommended that you use a controlled chamber when determining if Calibration

is necessary. Adjusting the pen locations in an open room is not recommended as humidity

can vary greatly within a very small area.

Dickson KT8P Manual V6 52418

ome is pressed the two pens will switch positions (moving the most

ome

On/Off

On/Off is pressed to exit pen adjust mode.

On/Off

Adjust- - - - Down

Adjust

Adjust- - - - Up

Up button. Pressing Pen home

Adjust

On/Off button. The adjustment is stored in memory

On/Off

Down button. To lower the unit of

Down

Pen home switches between the red and

Pen home

On/Off

On/Off and the

On/Off