Axis 2490 Panduan Memulai - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Server Axis 2490. Axis 2490 6 halaman. Serial server

AXIS 2490 Getting Started Guide

Refining the Installation

Click the Installation Wizard button. The wizard helps you complete the remaining

installation steps. For further configuration, click the Admin button. The buttons on the

Admin page provide access to general settings, port settings and settings for the network.

Admin

Button

Installation

Wizard

The information and screen examples shown here provide a very brief introduction to

configuring your AXIS 2490. For more detailed information, please refer to the AXIS 2490

User's Manual, which can be obtained from www.axis.com.

Reinstating the Factory Default Settings

In certain circumstances, it may be necessary to reinstate the Factory Default settings for

your AXIS 2490. This is performed by clicking the appropriate button within the

Administration Tools, or by pressing the Control Button. Follow the instructions below to

reinstate the product factory default settings using the Control button:

1. Switch off the AXIS 2490 by disconnecting the power cable.

2. Press the Control Button and keep it pressed. Reconnect the power supply cable.

3. With the Control button pressed, the Status Indicator will now flash briefly and then go out.

When the Status Indicator has been out for about 5 seconds, release the Control Button. When

the Status Indicator starts to flash again after approximately 5 seconds, the AXIS 2490 will then

have been reset to its default settings.

Note:

Reinstating the original default settings will cause all parameters (including the IP address) to be

reset.

Click the

icon to

configure

Page 4 of 5

On-line

Help

The mode

currently

selected