Alpha Microsystems AM-402 Panduan Petunjuk Instalasi - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Perekaman Alpha Microsystems AM-402. Alpha Microsystems AM-402 17 halaman. Scsi cd-recorder
Halaman CetakPage 9
The AMOS hidden sector parameters could not be calculated.
•
Error- Unable to remove CD-Recorder data buffer from memory.
•
Error - Unable to write AlphaCD special sector.
An error was received while trying to record the AlphaCD special sector.
•
Unable to continue due to one or more errors shown above.
Testing of logical disk drive transfer rates resulted in the errors listed above.
Normal informational messages:
•
A blank CD is in the CD-Recorder.
The CD media in the CD-Recorder is blank and unused. A blank CD does not require
filler and an AlphaCD special sector.
•
AlphaCD test complete
The test recording is done.
•
AlphaCD creation complete
The recording of data on the CDR media is done.
•
Are you sure you want to erase data from this CD (Y/N)?
If you really want to erase the CD, type Y
this was a mistake, type N
•
Calculating space requirements:
AMOS partition requires 16165 sectors
Filler requires 38127 sectors
Calculated starting AMOS sector is 251608
This shows information about where data will be recorded on the CD and how much
space it consumes.
•
CD-Recorder located at SCSI id n
This shows the SCSI id of the CD-Recorder being used.
•
Completely erase entire CD
MAKACD will erase all data from the rewritable CD. This writes to the entire CD and
can take 30 minutes or longer.
•
DSK0: 64660 blocks. Transfer rate: 1273K per second - ok
The disk transfer rates are being tested.
•
Erase last session on CD
MAKACD will erase the last session on the rewritable CD. This overwrites the entire
last session on the CD and can take 30 minutes or longer, depending on the size of the
session.
•
not calculated - disk is too small.
The specified disk is too small for speed testing. The disk will be copied to the CD.
•
Note that once started, the recording operation can be stopped by pressing ^C which will
render the CD-R disk unusable.
Warning: The CD-Recorder must receive data constantly. Other users on the system could
delay data transfers and render the CD-R disk unusable.
•
Press RETURN to start recording or ^C to abort.
This is the final prompt before recording begins. You may abort by pressing control-C
or start the recording process by pressing RETURN.
•
NOTE: Disk will be recorded as a multi-session recording
System Commands Reference Manual, Rev. 11
. The CD will be erased as requested. If
RETURN
and the program will exit without erasing the CD.
RETURN
MAKACD