Dictator E8 Panduan Teknis - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Sistem Kontrol Dictator E8. Dictator E8 19 halaman.

Halaman Cetak

Technical Manual E8

III/2 Parameter

Page 05.023.10

III. Adjustment / Programming - cont.

„P-0" Position of the door

The parameter P-0 shows the present position of the door when a drive

unit with integrated position control system is connected.

If separate limit switches are used, the values shown in the display have

the following signification:

000

Door is CLOSED (limit switch Door CLOSED has been actuated)

003

Door is OPEN (limit switch Door OPEN has been actuated)

The signification of the values 001/002 depends on the direction in

which the door is moving.

In OPENING direction:

001

Door moves at „normal" speed (between the positions of the

limit switches creep speed CLOSE and OPEN)

002

Door moves at creep speed

In CLOSING direction:

001

Door moves at creep speed

002

Door moves at „normal" speed (between the positions of the

limit switches creep speed CLOSE and OPEN)

„P-1" Crawling speed

This parameter permits to adjust the crawling speed before the position

OPEN. The control system automatically switches to this speed as soon

as the position „Crawling Speed OPEN" is reached (adjusted with the

parameter „P-8" or indicated by a separate limit switch).

This parameter, just as all following parameters, is adjusted with the

arrow membrane keys

value is memorized as soon as you change to another parameter or the

display changes back to „P-0"

The value for the crawling speed is adjusted ex works to 40 digits. It

can be increased to a maximum of 100 digits.

The crawling speed before the position Door CLOSED is set in the con-

trol system and cannot be adjusted. However it is possible to adjust the

distance before the position Door CLOSED where the motor changes to

the crawling speed (see parameter „P-9").

„P-2" Normal opening speed

With this parameter you can adjust the normal travel speed of the door

for opening. The control system switches automatically to this speed after

an initial acceleration.

The value for this speed is adjusted ex works at 150 digits. This value

can be reduced to min. 100 digits and increased to max. 200 digits

Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 20200703

and

on the lid of the casing. The adjusted