Didgeridoo Pulse Jet Engine Panduan Perakitan - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mesin Didgeridoo Pulse Jet Engine. Didgeridoo Pulse Jet Engine 9 halaman.

Halaman Cetak
8/9
8 8
5 5
4 4
7 7
10 10
12 12
11 11
13 13
TIP
To attach two wires with a Wire
Connector.
1. Pinch the ends of both wires
together and place the Wire
Connector over the top of them.
2. Twist the Wire Connector
clockwise.
INSTRUCTIONS
1
Cut two portions of the Electrical Wire at
arms length.
2
You should be left with three length of
Electrical Wire.
NOTE
6 6
Two wires should be arms length.
(Short Electrical Wire)
One wire should be roughly double the
length of the smaller wires.
(Long Electrical Wire)
3
Use the Wire Stripper to remove roughly a
9 9
fingers width of the plastic insulator on all
the ends of the Electrical Wires.
4
Grab one Short Electrical Wire and the
Power Controller.
5
Press the
RED
tab on the rear of the
Power Controller and insert one end of
the Short Electrical Wire into the hole that
opens up.
Use a Wire Connector to attach the other
6
end of the same Short Electrical Wire to
the
RED
wire on the Spark Plug.
7
Grab the second Short Electrical Wire.
8
Press the
BLUE
Power Controller and insert the Short
Electrical Wire into the hole.
Leave the other end of this wire dangling.
tab on the rear of the
9
Grab the long Electrical Wire.
Use a Wire Connector to attach one
10
end of the Long Electrical Wire to
the
GREEN
wire on the Spark Plug.
11
Connect the other end of the Long
Electrical Wire to the
the Battery.
TIP
To do this lift the tab on the battery
and insert the Electrical Wire into
the hole.
Press down on the tab until you hear
a "click".
12
Grab the dangling wire.
13
Connect the wire to the
on the Battery.
12' of Electrical Wire
After Cutting
Short (3 feet) x 2
Long (6 feet) x 1
Wire Connectors
TOOL LIST
Power Controller
Wire Stripper
Wire Cutter

Power Supply

Assembly
GREEN
tab on
BLUE
tab
PARTS LIST
Spark Plug
Battery