Alpha Professional Tools VSP-110 Catatan Teknis - Halaman 2

Jelajahi secara online atau unduh pdf Catatan Teknis untuk Sander Alpha Professional Tools VSP-110. Alpha Professional Tools VSP-110 3 halaman.

What shall I do if my VSP-110 breaks down and I need to complete the job immediately?

This largely depends upon the time frame involved. The first step would be to check and replace the carbon brushes.

Alpha Professional Tools® has two warranty service centers and can turn your tool repair around in a 3-5 day period.

Please contact Alpha® for information or send tool to your nearest regional repair center. For warranty repairs please

include a copy of the sales receipt. Visit our website for address information: http://www.alpha-tools.com/Contact.aspx

For additional information or alternative solutions. please contact our tool repair department.

The GFCI is tripping frequently. What I can I do?

If the GFCI is tripping frequently, there could be several problems.

1. Water is getting inside the polisher. Dry the tool with compressed air and try to prevent water from getting into the

polisher.

2. The voltage drops due to sharing the same power source in a work area.

3. Too much force is applied to the tool. Back-off on the pressure.

4 The outlet may be loose. Make sure the power cord plug is tightly inserted in the power outlet.

5. Contact Alpha Professional Tools® tool repair department for further advice.

If my VSP-110 breaks down, whom should I contact for repair?

Contact the dealer where you purchased the tool or Alpha Professional Tools® directly at 800-648-7229.

Can I use my VSP-110 as a wet cutting tool with a diamond blade?

No. The VSP-110 only has a 2,800 no load RPM rating. This is not enough RPM for cutting applications with a diamond

blade. It is unsafe to use the VSP-110 as a cutting tool. Do not attempt to cut with the VSP-110.

Can I use my VSP-110 for dry polishing applications?

No. The VSP-110 is designed for wet use only. Alpha® recommends using our AWP-158/214 for dry polishing

applications.

How can I get the parts list and schematic for the VSP-110?

There are several ways to obtain information such as this from Alpha Professional Tools®. It is available on our web

site www.alpha-tools.com or by contacting our Tool Dept Help Desk at 800-648-7229.

What is the proper RPM for polishing Engineered Stone?

Any RPM range on this polisher will work for polishing engineered stone. Using slower RPM together with the Alpha®

Ceramica EX will provide the optimum polish on engineered stone material.

What is the largest diameter accessory that the VSP-110 will accept?

The VSP-110 will accept accessories up to 5". Do not attempt to use accessories larger than 5" for safety reasons. In

addition, large accessories require more torque than the VSP-110 can provide. Operating the VSP-110 under these

conditions will result in overheating failure.

Can I use the VSP-110 for drilling applications such as faucet holes?

Yes. The VSP-110 can be used with Alpha® Core Bits to drill faucet mounting holes. We recommend using the

provided C-Handle attachment and a template.

How many gallons of water does the Alpha® VSP-110 use per minute?

The Alpha® VSP-110 has a throughput of approximately 1.1 gallons per minute with the water valve fully open.

Document # 6480 - Rev.-September 2007

www.alpha-tools.com

Page 2 of 3