DieHard 200.71224 Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengisi Daya Baterai DieHard 200.71224. DieHard 200.71224 17 halaman. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
Juga untuk DieHard 200.71224: Panduan Pemilik (16 halaman)
Halaman Cetak
It is important
to understand
your charger's
requirements.
This section
will tell you
about
your charger's
electrical
requirements
and how to prepare
a battery
for
charging.
ASSEMBLING
YOUR CHARGER
Included with your battery charger are two
cord wrap cleats for storage of the clamp
cables.
To install, align the three tabs to corre-
spond with the three receptacles and push
until you hear a snap.
Wrap clamp cord after unplugging
the
power cord and store your charger in a
dry location.
PLUGGING
IT IN
Your charger requires a 120V AC
receptacle installed according to all
local codes and ordinances.
[_)
('-Cord Wrap Cleat
USING AN EXTENSION CORD
The use of an extension cord is not
recommended.
If you must use an
extension cord, please make sure
that you follow these guidelines:
• Make sure that the pins on charger's
power cord fit firmly into the extension
cord, and that the extension cord fits
firmly into the receptacle.
• Check that the extension cord is
properly wired and in good electrical
condition.
Make sure that the wire size is large
enough for its length and for the AC
ampere rating, as specified in the
chart below.
.........
!ii!i!!i iii
.......
ii ¸
! iiiiiil
Length of Cord, inFeet
25
50
100
150
AWG* Size of Cord
18
16
12
10
*AWG-American WireGauge
5