DieHard 28.71221 Panduan Operator - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pengisi Daya Baterai DieHard 28.71221. DieHard 28.71221 11 halaman. 12v manual battery charger

Halaman Cetak

DC CONNECTION PRECAUTIONS

5.1

Connect and disconnect the DC output clips only after setting all of the charger switches

to the "off" position (if applicable) and removing the AC plug from the electrical outlet.

Never allow the clips to touch each other.

5.2

Attach the clips to the battery and chassis, as indicated in sections 6 and 7.

FOLLOW ThESE STEPS WhEN BATTERY IS INSTALLED IN VEhICLE

6.1

Position the AC and DC cables to reduce the risk of damage by the hood, door and

moving or hot engine parts. NOTE: If it is necessary to close the hood during the

charging process, ensure that the hood does not touch the metal part of the battery clips

or cut the insulation of the cables.

6.2

Stay clear of fan blades, belts, pulleys and other parts that can cause injury.

6.3

Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post usually

has a larger diameter than the NEGATIVE (NEG, N, -) post.

6.4

Determine which post of the battery is grounded (connected) to the chassis (vehicle

frame). If the negative post is grounded to the chassis (as in most vehicles), see step

6.5. If the positive post is grounded to the chassis, see step 6.6.

6.5

For a negative-grounded vehicle, connect the POSITIVE (RED) clip from the battery

charger to the POSITIVE (POS, P, +) ungrounded post of the battery. Connect the

NEGATIVE (BLACK) clip to the vehicle frame or engine block at a distance away from

the battery. Do not connect the clip to the carburetor, fuel lines or sheet-metal body

parts. Connect to a heavy gauge metal part of the vehicle frame or engine block.

6.6

For a positive-grounded vehicle, connect the NEGATIVE (BLACK) clip from the battery

charger to the NEGATIVE (NEG, N, -) ungrounded post of the battery. Connect the

POSITIVE (RED) clip to the vehicle frame or engine block at a distance away from the

battery. Do not connect the clip to the carburetor, fuel lines or sheet-metal body parts.

Connect to a heavy gauge metal part of the vehicle frame or engine block.

6.7

Connect charger AC supply cord to electrical outlet.

6.8

When disconnecting the charger, turn all switches to off, disconnect the AC cord, remove

the clip from the vehicle chassis and then remove the clip from the battery terminal.

6.9

See CALCULATING CHARGE TIME for length of charge information.

NEgATIVE gROUNDED SYSTEM

•

A SPARK NEAR ThE BATTERY MAY CAUSE

A BATTERY EXPLOSION. TO REDUCE ThE

RISK OF A SPARK NEAR ThE BATTERY:

•