DieHard 28.71486 Panduan Operator - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Operator untuk Starter Jarak Jauh DieHard 28.71486. DieHard 28.71486 12 halaman. Jump starter and dc power source
Halaman Cetak
11.
tROUBLESHOOtInG
PROBLEM
The jump starter won't jump
start my car.
The jump starter won't
power my 12v device.
The battery in the jump
starter won't hold a charge.
The jump starter alarm is
on.
12.
SPECIFICAtIOnS
Internal Battery Type
Nominal voltage
Capacity
dC Power Outlet (Max. Continuous Load)
Built-in Light Bulb (Replaceable)
Jumper Cables
dimensions (H x W x d)
Product Weight
13.
REPLACEMEnt PARtS/ACCESSORIES
Male-to-Male Accessory 12v Charging Connector ----------------------- 94500109
POSSIBLE CAUSE
Clips are not making a good
connection to the battery.
The jump starter battery is
not charged.
The vehicle's battery is
defective.
The 12v device is not
turned on.
The jump starter battery is
not charged.
The 12v device draws more
than 15A or has a short
circuit
The battery is bad (will not
accept a charge).
Connections are reversed.
dieHard Maintenance-free AgM Lead-acid
12v dC
12 Ah
15A With Automatic Circuit Breaker Reset
5w/12v dC (Base type BA9S)
8-gauge AWg, 18 Inches
9.5 H x 10 x 8 Inches
12.2 Lbs.
9
•
•
REASOn/SOLUtIOn
Check for poor connection
to battery and frame. Make
sure connection points
are clean. Rock the clips
back and forth for a better
connection.
Check the battery charge
status by pressing the button
on the front of the jump
starter. See LEd Indicators
section of this manual.
Have the battery checked.
Turn on the 12v device.
Check the battery charge
status by pressing the button
on the front of the jump
starter. See LEd Indicators
section of this manual.
disconnect the 12v device.
The internal breaker will
automatically reset after a
minute or two. Try the 12v
device again. If it happens
again, replace the 12v
device.
Have the battery checked.
disconnect the jump starter
and reverse the clips.