DieHard 28.71494 Panduan Operator - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Operator untuk Inverter DieHard 28.71494. DieHard 28.71494 14 halaman. 750 watt power inverter

NOTE: If more than one device is to be powered, start one device at a time to avoid

a power surge and overloading the inverter. The surge load of each device should

not exceed the inverters Continuous Operation wattage rate.

If there is a short circuit or power surge in the device,  will display

and the alarm will sound. Press the ON/OFF switch to turn off the alarm. If the 

displays after several attempts, there is a short circuit or the device requires more

"starting" or "peak" load than the inverter is capable of providing.

If you are using the power inverter to operate a battery charger,

monitor the temperature of the battery charger for about 10 minutes. If the battery

charger becomes abnormally warm, disconnect it from the inverter immediately.

NOTE: You can use an extension cord from the inverter to the device without

significantly decreasing the power being generated by the inverter. For best

operating results, the extension cord should be no longer than 50 feet.

Using the USB Port

The USB port provides up to 500mA at 5V DC.

Plug the device into the USB port.

Turn the USB device on.

Reverse these steps when finished using the USB port.

Using the Inverter to Operate a Tv or Audio Device:

The inverter is shielded and filtered to minimize signal interference. Despite this,

some interference may occur with your television picture, especially with weak

signals. Below are some suggestions to try and improve reception.

Make sure the television antenna produces a clear signal under normal

operating conditions (i.e. at home plugged into a standard 120-volt AC wall

outlet). Also, ensure that the antenna cable is adequately shielded and of

good quality.

Try altering the position of the inverter, antenna cables, and television

power cord. Add an extension cord from the inverter to the TV so as to

isolate its power cord and antenna cables from the 12-volt power source.

Try coiling the television power cord and the input cables running from the

12-volt power source to the inverter.

Affix one or several "Ferrite Data Line Filters" to the television power cord.

Ferrite Data Line Filters can be purchased at most electronic supply stores.

NOTE: You may hear a "buzzing" sound being emitted from inexpensive sound

systems when operated with the inverter. This is due to ineffective filters in the

sound system's power supply. Unfortunately, this problem can only be resolved by

purchasing a sound system with a higher quality power supply or higher quality filter.

• 7 •