DieHard 28.71225 Panduan Operator - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pengisi Daya Baterai Mobil DieHard 28.71225. DieHard 28.71225 20 halaman. 12v battery charger & engine starter

Halaman Cetak

Desulfation Mode

If the battery is left discharged for an extended period of time, it could become

sulfated and not accept a normal charge. If the charger detects a sulfated

battery, the charger will switch to a special mode of operation designed for

such batteries. If successful, normal charging will resume after the battery is

desulfated. Desulfation could take 8 to 10 hours. If desulfation fails, charging

will abort, the CHECK (red) LED will blink and the digital display will show a

failure code of F02 (Bad Battery).

completion of charge

Charge completion is indicated by the CHARGED (green) LED. When lit, the

charger has switched to the Maintain Mode of operation. If the 12V DEEP

CYCLE battery type was selected, the CHARGED (green) LED comes on

when the battery is charged enough for normal use.

Maintain Mode (float-Mode Monitoring)

When the CHARGED (green) LED is lit, the charger has started Maintain

Mode. In this mode, the charger keeps the battery fully charged by delivering

a small current when necessary. If the battery voltage drops below a preset

level, the charger will go back into Charge Mode until the battery voltage

returns to the full charge level, at which point the charger will return to Maintain

Mode. The voltage is maintained at a level determined by the BATTERY

TYPE selected.

NOTE: The charger automatically switches between Charge Mode and

Maintain Mode as necessary. The CHARGED LED will cycle on when the

battery is at full charge and off when the voltage drops below a preset level

and the charger goes into Charge Mode. This cycle will continue, and the

CHARGED LED will stay on for longer periods of time as the battery becomes

more fully charged.

NOTE: The maintain mode technology utilized in DieHard chargers allows

you to safely charge and maintain a healthy battery for extended periods of

time. However, problems with the battery, electrical problems in the vehicle,

improper connections or other unanticipated conditions could cause excessive

voltage draws. As such, occasionally monitoring your battery and the charging

process is recommended.

Using the Engine Start feature

Your battery charger can be used to jumpstart your car if the battery is low.

Follow these instructions on how to use the ENGINE START feature.

Follow all safety instructions and precautions for charging

your battery. Wear complete eye protection and clothing protection. Charge

your battery in a well-ventilated area.

Using the ENGINE START feature WITHOUT a battery

installed in the vehicle could cause damage to the vehicle's electrical system.

NOTE: If you have charged the battery and it still will not start your car, do not

use the engine start feature, or it could damage the vehicle's electrical system.

With the charger unplugged from the A.C. outlet, connect the charger to

the battery following the instructions given in section 6: FOLLOW THESE

STEPS WHEN BATTERY IS INSTALLED IN VEHICLE.

Plug the charger AC power cord into the AC outlet.

With the charger plugged in and connected to the battery of the vehicle, set

the charge rate selector button to the engine start position.

Crank the engine until it starts or 5 seconds pass. If the engine does not

start, wait 3 minutes before cranking again. This allows the charger and

battery to cool down.

•