Olympus BHTU Petunjuk Manual - Halaman 12

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Olympus BHTU. Olympus BHTU 22 halaman. Reverse nosepiece
Juga untuk Olympus BHTU: Pembongkaran, Pembersihan, dan Pemasangan Kembali Lengkap (19 halaman)

Halaman Cetak

1. Troubleshooting Guide

Cover Glass

•

An Olympus objective engraved "16010.17" requires a

cover

glass of 0.17mm thickness.

the numerical aperture of the objective is 0.7 or higher (except immersion objectives)

and no correction collar is provided, the resolving power deteriorates greatly, if

cover

glass thickness deviates from the above listed value.

NOTE: In some countries a 0.17 mm thick cover glass corresponds to a #1

cover glass.

•

A cover glass (0.4 mm thick) for blood counting, etc. can be used with Olympus objectives

except 0 Plan 40X. S Plan Apo 40X and S Plan lOOX.

Specimen Slide

•

Specimen slides 0.8 mm to 1.5 mm thick are

recommended for Olympus objectives.

•

Specimen slides 0.8 mm to 1.2 mm thick are

recommended for, the dark field condenser

and the

fferential interference contrast

con~

denser.

Bring the portion of the specimen to be

observed into the light path by means of the

low drive stage control knobs. (Fig. 9)

Tighten the stage clamping screw

<D .

Stage

• The specimen holder can accommodate two

standard specimen slides simultaneously.

• The specimen holder is removalbe to obtain

a large unobstructed stage surface to hold

specimens up to 55 mm x 85 mm.

•

To rotate the stage loosen the $tage clamping

screw

and holding this screw, rotate the

stage into the desired direciton. (Fig.

10)

Stage clips for use with immersion objectives.

(Fig. 111

A pair of stage clips is optionally available

to hold the specimen on the stage, elimina-

ing specimen drag or buckling due to immer-

sion oil between slide and stage surface. The

ips can be inserted into the holes

provided on the specimen holder.

Fig.10

Fig. 11