Olympus BX3-MDOE Petunjuk Manual - Halaman 28

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Olympus BX3-MDOE. Olympus BX3-MDOE 40 halaman. For 2, 5, 9, 10 and 13 persons

Move the

portion shown in the picture up and down so that the

d portion of the stand is 71 mm, and tighten the stand height lock

knob e .

If there is a difference in height between the desk top surface

TIP

where the microscope frame is installed and the desk top

surface where U-MDOSV is installed, adjust the length of the

d portion of the stand. For example, if the height difference

is 5 mm (if the desk top surface of the microscope frame is

higher than the desk top surface of U-MDOSV), d will be 76

mm.

Attaching U-MDOSV

Remove the cap from the mount a on BX3-MDOE and the cap from

the mount b on U-MDOSV.

Return the vertical direction of U-MDOSV where the stand is attached

to the original direction. Insert b of U-MDOSV into the mount a on

BX3-MDOE completely to the end.

While holding the base c of the stand firmly with your hand, rotate

the mount ring d to secure U-MDOSV to BX3-MDOE.

After the mount ring d is rotated completely, make sure

NOTE

that the stand is installed on the desk securely. Insert a

sheet of paper between the base of the stand and the

desk. If the paper touches three rubber legs, the stand is

installed securely. If the paper does not touch even one

rubber leg, perform

See "Attaching the observation tube" in "5-2 Side by side

observation system for 2 persons and system for 5 persons" (page

19).

again.