Olympus BXFM-ILH Petunjuk Manual - Halaman 29

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Olympus BXFM-ILH. Olympus BXFM-ILH 36 halaman. Focusing unit

Fig. 23

Fig. 24

Fig. 25

...

†

Fig. 26

Attaching the Eyepiece

Gently insert the eyepiece all the way into each eyepiece sleeve.

# When using the U-BI30-2 binocular tube, eyepieces with built-in mi-

crometer disk cannot be attached.

# When using a finder eyepiece or an eyepiece with micrometer disk,

attach it to the right-hand eyepiece sleeve.

When doing so, make sure that the eyepiece positioning pin @ fits

into the notch ² on the eyepiece sleeve.

# The super widefield trinocular observation tube is equipped with a

positioning notch on both eyepiece sleeves. Make sure that the

positioning pins on both eyepieces fit into the respective notches.

Attaching the Halogen Bulb

}The applicable lamp bulb is the 12V100WHAL-L (PHILIPS 7724) or the

12V50WHAL-L (LIFE JC).

1. Loose the clamping screw @ on the top of the lamp housing using the

Allen screwdriver provided with the focusing unit.

2. Remove the lamp housing by lifting it up.

3. Tilt the lamp socket ³ by 90° toward the direction of the arrow.

4. While pushing down the bulb clamping lever | down, hold the bulb ƒ

with a glove or piece of gauze and insert the pins ... into the sections †

as far as they will go.

To prevent reduced bulb life or cracking, do not touch the bulb with

bare hands. If fingerprints are accidentally left on the bulb, wipe the

bulb with a soft cloth.

5. Attach the lamp housing from up and tighten the clamping screw @ by

pushing it downward. (Fig. 24)

Caution for Bulb Replacement During or Right After Use

The bulb and the lamp socket are areas near these will be extremely

hot during and right after use.

Set the main switch to "

the wall outlet, then allow the old bulb and lamp housing to cool

before replacing the bulb with a new of the designated type.

(Figs. 24 - 26)

" (OFF), disconnect the power cord from

BXFM

(Fig. 23)