Olympus PT-058 Buku Petunjuk - Halaman 5
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Kamera Olympus PT-058. Olympus PT-058 30 halaman.
Chemicals which cannot
be used
Volatile organic solvents,
chemical detergents
Anticorrosion agent
Commercial defogging
agents
Grease other than
specifi ed silicone grease
Adhesive
6 Jumping into the water with the Case in your pocket or in your hand,
throwing the Case from a boat or ship into the water, and other rough
handling may cause water leakage. Please handle with suffi cient
care, when handing it over from hand to hand etc.
7 If the Case interior or the camera should become wet because of
water leakage, etc., immediately wipe off all moisture and contact
your local service station or dealer.
8 Please remove the O-ring when traveling by air. Otherwise air
pressure may make it impossible to open the Case.
9 For safe use of the digital camera in this product, please read the
"Instruction Manual" for the digital camera carefully.
0 When sealing this product, take suffi cient care that no foreign matter
gets caught at the O-ring and the contact surface. It is caused for
water leakage.
a When you install your digital camera in the Case after taking pictures
in the water, it may cause the loss of transparency of the lens inside
even if you insert the supplied silica gel to the Case when drying the
camera is insuffi cient.
Explanation
Do not clean the Case with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Use pure water or
lukewarm water.
Do not use anticorrosion agents. The metal parts
use stainless steel or brass. Wash with pure
water.
Do not use commercial defogging agents. Always
use the specifi ed desiccant silica gel.
Use only the specifi ed silicone grease for the
silicone O-ring, as otherwise the O-ring surface
may deteriorate and water leakage may occur.
Do not use adhesive for repairs or other purposes.
When repair is required, please contact a dealer or
a service station of OLYMPUS CORPORATION.
EN
EN 33