Olympus PT-EP06 Buku Petunjuk - Halaman 19

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Aksesori Kamera Olympus PT-EP06. Olympus PT-EP06 24 halaman.

PT-EP06_EN.Book Page 18 Monday, September 26, 2011 5:01 PM

7. Maintaining the waterproof function

The O-ring is a consumable product. Before each use, perform proper maintenance. Always be sure to

perform the O-ring maintenance operation as described below. Neglecting this maintenance may

become the cause of water leakage.

Perform at the location without sand or dust, after washing and drying your hands.

Open the Case and remove the O-ring.

Procedure

1 Insert the O-ring remover into the gap between the O-ring and O-ring groove wall.

2 Bring the tip of the inserted O-ring remover below the O-ring. (Be careful not to damage the groove

with the tip of the O-ring remover.)

3 Lift the O-ring, pinch it with your fingertips and pull it out of the Case.

After visually checking that dirt has been removed from the O-ring, check for attached sand and other

foreign matter, as well as for damage and cracks by squeezing the entire circumference of the O-ring

lightly with your fingertips.

Remove attached foreign matter from the O-ring groove with a clean cloth or a cotton swab. Also remove

any sand or dirt attached to any part of the Case that comes into contact with the O-ring.

CAUTION:

• When a sharp object is used to remove the O-ring or to clean the inside of the O-ring groove, the Case and

the O-ring may be damaged and water leakage may be caused.

• When the O-ring is checked with the fingertips, take care not to stretch the O-ring.

• Never use alcohol, thinner, benzene or similar solvents or chemicals detergents to clean the O-ring. When

such chemicals are used, it is likely that the O-ring will be damaged or that its deterioration will be

accelerated.

Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the O-ring, and

fit the O-ring into the groove. At this time, confirm that the O-ring does not stick out from the groove.

When sealing this product, make sure that no hairs, fibers, sand particles or other foreign matter stick

not only to the O-ring, but also to the contact surface (front cover). Even a single hair or a single grain of

sand may cause water leakage. Please check with special care.

EN 18