Olympus PSD-10 Petunjuk Manual - Halaman 15

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Medis Olympus PSD-10. Olympus PSD-10 28 halaman. Electrosurgical unit

5-3 Connection of Footswitch

Red mark

Red mark

P-cord connector

Terminal

S-cord

connector

Patient-

S-cord connector

plate

mount

Disposable

patient plate

Lever

Clamp

Terminal

Connection of disposable patient plate

Connect the footswitch to the FOOT SW. connector on the PSD-10, with

the red positioning dot on the plug facing upward. Fully tighten the clamp-

ing ring on the plug by turning clockwise.

Connect the S-P cord to the PATIENT connector on the PSD-10, with the

red dot facing upward. Push the plug until it is locked in place.

Connect the P-cord connector to the Patient-plate. Fully tighten the clamping

ring.

Connect the S-cord to the endoscope (S-cord connector mounted on the

light guide connector), which has been plugged in the output socket of the

light source. Fully tighten the clamping ring.

The alarm will be activated when the power switch is turned on, if above

connections (Steps

through

In case a disposable patient plate (Scotchplate

Lift the lock lever of the special S-P cord (MB-583, optional) and insert the

terminal of the patient plate into the port. Press the lever back down to secure

plate.

Non-Controlled Document

are defective.

#1149, 3M) is being used: