Olympus ScopeGuide UPD-3 Panduan Referensi Cepat

Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Peralatan Medis Olympus ScopeGuide UPD-3. Olympus ScopeGuide UPD-3 2 halaman.

Halaman Cetak

ScopeGuide

Quick Reference Guide

ScopeGuide is designed to provide a real-time 3D image of the shape and configuration of the

colonoscope inside the body.

CAUTION:

This quick reference guide is only a summary of the ScopeGuide Instructions for Use. For detailed operating instructions, be sure to follow the ScopeGuide

(UPD-3) Instruction Manual that was included with your ScopeGuide (UPD-3) purchase.

Connect the receiver dish to the UPD-3 via the receiver dish

cable (MAJ-1875).

Use the ScopeGuide-enabled CF-HQ190L colonoscope or

connect the MAJ-1878 probe to the UPD cable (MAJ-1881) for

use with a non-ScopeGuide enabled colonoscope.

Connect the hand coil (MAJ-1859) to the UPD-3.

1. Menu

Press to display or exit the menu list.

Press rotate to change the orientation of the patient image if the

2. Rotate

patient's position on the stretcher changes.

Press to magnify and reduce the endoscope model display if the image

size on the screen is not optimal. Zoom is also helpful if capturing

3. Zoom

images for procedure reports. Magnify the ScopeGuide image to ensure

it is visible in small report images.

Press to mark an area of interest or polyp on the insertion length of the

4. Bookmark

scope for reference. Note that actual locations of bookmarked areas

may vary if loops are reduced while manoeuvering to reach the cecum.

5. Split screen

Press to alternate between split-screen and single-screen display.

Press to set or release the endoscope start position. This enables the

6. Scope position

processor to measure the length of the scope within the patient.

7. Reset

Press to return to default ScopeGuide settings.

( UPD-3 )

Pre-Procedure Checklist

ScopeGuide Functions

Use the arrow keys or the remote control to change the

orientation of the scope image to correspond with the

positioning of the patient after the system is powered on.

Position the receiver

dish (MAJ-1868) next

to the stretcher and

up and over the bed

rail, then align the right

edge of the receiver

dish with the patient's

anus.

Set the starting

position by holding the

endoscope tip and the

hand coil close to the

anus. Then press the

scope position button.