Olympus SZ2-STU1 Petunjuk Manual - Halaman 14

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Laboratorium Olympus SZ2-STU1. Olympus SZ2-STU1 20 halaman. Universal stand, table clamp stand

Halaman Cetak

OPERATION

Fig. 16

Fig. 17

Fig. 18

1. To move the horizontal arm horizontally, loosen the horizontal clamping

knob @.

The tension of the horizontal movement can be adjusted with the

horizontal movement tension adjustment knob ². Rotating the knob

in the direction of the arrow increases the tension and rotating in the

opposite direction decreases it. (Fig.16)

Do not decrease the tension too much, as too quick movement may

pinch your hand and cause injury.

2. To rotate the horizontal arm around the column, loosen the vertical clamp-

ing lever @. This rotation is limited to 90° by the rotation stopper of the

drop prevention ring. The rotation range can be set to the front 90°

range, which renders the system most stable, by orienting the clamping

knob ² of the drop prevention ring so that it points the front of the

stand. (Fig. 17)

To ensure safety, use the most stable rotation range unless other

range is required for a special purpose.

3. To move the horizontal arm upward, keep the drop prevention ring @

clamped but loosen the vertical clamping lever ². After lifting the

horizontal arm ³ to the desired position, tighten the vertical clamping

lever again. And then move up the drop prevention ring till immediately

beneath the horizontal arm section and clamp the ring again.

To move the horizontal arm downward, confirm that the vertical clamping

lever ² is clamped and move down and clamp the drop prevention

ring. And then, holding the horizontal arm, loosen the vertical clamping

lever and move down the horizontal arm gently.

Never loosen the clamping knob of the drop prevention ring @

and vertical clamping lever ² simultaneously, as this is extremely

dangerous.