Axler CS-CPS-20a Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori Kamera Axler CS-CPS-20a. Axler CS-CPS-20a 6 halaman.

M O U N T I N G Y O U R C A M E R A / T R I P O D

H E A D T O T H E S L I D E R

Important!

Before mounting your camera, lock down the

camera base by tightening the brake.

The camera base's 1/4"-20 mount comes with the

included 3/8"-16 bushing preinstalled. If your tripod

head has a 1/4"-20 socket, remove the 3/8"-16

bushing from the mount before attaching your

tripod head.

To mount a camera or tripod head, follow these steps:

1. Loosen the mounting plate locks and remove the

top mounting plate from the camera base. (Fig. 4)

2. Align the mounting post with the mounting

socket of your camera or tripod head, and screw

the top mounting plate in. (Fig. 5)

Use a Phillips screwdriver to fully tighten.

3. Place the assembly onto the camera base, and

tighten the mounting plate locks until secure.

Note: For heads that are wider than the mounting

plate, use the included set screws and T9 hex

keyto tighten the mounting plate to the slider.

U S I N G T H E S L I D E R

Once your camera is mounted, loosen the brake

and use your tripod head's pan handle to move your

camera along the slider. If the slider is positioned at

an incline, keep one hand on the camera base before

loosening the brake.

S P E C I F I C A T I O N S

• Slide length:

• Max load capacity:

• Mount size:

• Drive type:

• Dimensions

• Weight:

(L × D × H)

Unmounted: 18" (45.7 cm)

Mounted: 30" (76.2 cm)

12 lb. (5.4 kg)

Camera: 1/4"-20

(3/8"-16 bushing included)

Tripod: 1/4"-20 and 3/8"-16

Belt

20.5" × 3.4" × 2.5"

(52.1 × 8.6 × 6.4 cm)

3.85 lb. (1.75 kg)