Axminster UV-180DS Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat Axminster UV-180DS. Axminster UV-180DS 20 halaman. 7 inch. engineer series

Halaman Cetak
6.
Carefully remove old blade. Caution: blade
teeth are sharp. Handle with care.
7.
Install new blade (E) by placing blade between
blade guides (F) first. Make sure blade teeth
face the same direction as indicated on the
label found on the saw bow.
8.
Place blade around both wheels. Make sure
the blade back edge rests near the wheel
flange on both wheels.
9.
Turn blade tension knob clockwise to tension
blade to tighten until the red line approach to
central line (B, Fig. 11). Do not over tension.
10. Put on the blade guards and tighten blade
guard nuts and screws
11. Close blade wheel cover and secure with lock
screws.
12. Connect machine to the power source.
13. Run saw and make sure blade is tracking
properly.
It is essential the guards be installed after the new
blade has been fitted.
Failure to comply may cause serious injury!
B
F i g. 1 2
D
C
F i g. 1 3

Adjusting Blade Square to Table

1.
Disconnect machine from the power source.
2.
Place machinist's square on the table next to
the blade as in Figure 14.
3.
Check to see blade makes contact with the
square along the entire width of the blade.
4.
If adjustment is necessary, loosen bolt (A, Fig.
14) and rotate blade guide assemblies slightly
in the same direction until blade makes contact
with the square along its entire width.
5.
Tighten bolts (A, Fig. 14).
WARNING
A
E
C
F
6.
Connect machine to the power source.
Note: If adjustment to square blade to table is
necessary, be sure to check blade adjustments
again.
A

Adjusting Blade Square to Vise

1.
Disconnect machine from the power source.
2.
Place a machinist's square as pictured in Fig.
15 square should lie along entire length of vise
and blade without a gap.
3.
If adjustment is necessary, loosen saw frame
lock bolts and swiveling saw frame to match
with vise square so that square lines up
properly. Tighten lock bolts.
4.
Connect machine to the power source.

Adjusting Blade Tracking

F
Blade tracking adjustment requires running the saw
with the back cover open. This adjustment must be
completed by qualified persons only!
Failure to comply may cause serious injury!
Note: Before making any tracking adjustments, try
a new blade. Warped blades do not track well.
Blade tracking has been set at the factory and
should not require adjustment. If a tracking
problem occurs, adjust the machine as follows:
5
Fig. 14
Fig. 15
WARNING