Axminster AW1416VS Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Bubut Axminster AW1416VS. Axminster AW1416VS 20 halaman. Woodturning lathe

Halaman Cetak

Specification...

A X M I N S T E R

W H I T E

Axminster No.

Rating:

Power:

Speed:

Spindle Taper:

Spindle Thread:

Taper Tailstock

Distance Between Centres:

Max Diameter Over Bed:

Tool Rest Stem Diameter:

Overall L x W x H:

Weight:

Please read the Instruction Manual prior to using your new machine; as well as the operating

procedures for your new machine, there are numerous hints and tips to help you to use the machine

safely and to maintain its efficiency and prolong its life. Keep this Instruction Manual readily accessible

for any others who may also be required to use the machine.

Assembly Instructions...

Please take some time to read the section entitled "Illustration & Parts Description" to identify the

various parts of your machine so that you are familiar with the terminology we will use to enable you

to set up and operate your table lathe safely and correctly.

The machine and its accessories will arrive coated with corrosion preventative grease. This will need to

be cleaned from the machine, its components and accessories prior to it being set up and

commissioned. Use coal oil, paraffin or a proprietary degreaser to remove the barrier grease. Be

warned, it will stain if you splash it on clothing etc., wear overalls, coverall et al., rubber gloves are also

a good idea, as is eye protection if your cleaning process tends to be a little bit enthusiastic. After

cleaning, lightly coat the machine with a thin layer of light machine oil. N.B If you used

paraffin/kerosene make sure you apply this thin film sooner rather than later.

95% of the machine comes fully assembled, (See what's in the Box) to assemble the remaining 5%

please follow the instructions below.

Assembling the Carrying handles

Locate the two steel carrying handles (E) & the four

M6 x 16mm phillips screws, attach them to each end

of the lathe bed (See fig 1).

865 x 330 x 415mm (With Extension Bed: 1465 x 330 x 415mm)

230V 50Hz 560W

0-800,200-1,750, 400-3,600rpm

M33 x 3.5mm (Ref T38)

AW1416VS

Trade

2MT

400mm

350mm

25.4mm

41kg

Fig 1