Axminster CSC500C Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Axminster CSC500C. Axminster CSC500C 8 halaman. Woodturning chuck set

Mounting the Chuck to Your Lathe...

Screw the completed assembly onto your lathe. The chuck should go on effortlessly with no

binding. Screw the chuck all the way until the adapter face contacts the shoulder of the

lathe spindle. Lock the spindle, slightly unscrew the chuck and give it a firm spin. This will

snap the chuck firmly in place.

Your chuck has two movable discs. Each disc has 4 holes to accommodate the tightening

levers. Insert a tightening lever into one of the holes on each level. Rotate the tightening

levers away or toward each other to close or open the chuck. Clockwise tightens,

counter-clockwise loosens the jaws.

When turning a bowl, for safety reasons, allow a minimum amount of wood for the chuck to

grab while turning.

1. Cavity base (inside grip) - for a 2" diameter base, minimum hole depth is 3/16".

2. Spigot base (outside grip) - for a 2" diameter base minimum grip is 3/16".

Turning: 500-I500rpm

Sanding & Polishing: 1500-2500rpm

Make sure your wood is properly aligned and balanced

when mounted or re-mounted.

Use slower speeds for larger work.

0800 371822

FREEPHONE