Axminster PROFESSIONAL 103738 Petunjuk Asli - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Asli untuk Peralatan Axminster PROFESSIONAL 103738. Axminster PROFESSIONAL 103738 2 halaman.

Platen

Setting the Bar to the Platen

Method One

Setting the Bar at 90˚ to the Platen

Using a digital leveling box check the suport bar is perpendicular

to the platen. Place the leveling box onto the bar, it should read

'ZERO' on the display. If adjustment is required, lightly loosen the

four Hex screws and adjust the support bar until the 'Bar' is in

line with the platen, nip up the Hex screws to secure the

assembly.

Ultimate Edge Angle Guage

The 'Angle Gauge' tool is a quick and easy way to accurately set

the correct clearence between the platen and the support bar.

The gauge has five preset stops from 20˚ to 40˚ degrees. The

gauge also incorporates a 25mm projection stop to set the

correct projection of the chisel out from the 'Honing Guide'

assembly.

Linisher

Bar

Hex screw

Steel frame

0.5 to 1mm

Clearance

Loosen the two threaded studs holding the platen. Adjust the

platen so it projects out from the steel frame of about 0.5 to

1mm. Tighten the studs to secure the platen in place.

Method Two

Alternatively place a 90˚ square on the bar and check its in line

with the edge of the platen and make adjustments accordantly.

Square to the

platen

Gap