Axminster AW12BM Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Bor Axminster AW12BM. Axminster AW12BM 20 halaman. 12mm bench morticer

Initial Actions

Having unpacked your machine and its accessories, please check the contents against the

equipment list "What's in the box", if there are any discrepancies, please contact Axminster

Power Tool Centre using the procedures laid down in the catalogue. Please dispose of the

packaging responsibly; much of the material is bio-degradable. The machine and its accessories

will arrive coated with heavy corrosion preventative grease and greased wax paper. These will

need to be cleaned from the machine, its components and accessories prior to it being set up

and commissioned. Use coal oil, paraffin or a proprietary degreaser to remove the barrier grease.

Be warned, it will stain if you splash it on clothing etc.; wear overalls, coverall et al., rubber

gloves are also a good idea, as is eye protection if your cleaning process tends to be a little bit

enthusiastic. After cleaning, lightly coat the exposed metal surfaces of the machine with a thin

layer of light machine oil. N.B If you used paraffin/kerosene make sure you apply this thin film

sooner rather than later.

Please read the Instruction Manual prior to using your new machine; as well as the

installation procedure, there are daily and periodic maintenance recommendations to

help you keep your machine on top line and prolong its life. Keep this Instruction Manual

readily accessible for any others who may also be required to use the machine.

Work Place/Environment/Installation

Mains Powered Machines

Primary Precautions

These machines are supplied with a moulded 13 Amp. Plug and 3 core power cable. Before

using the machine inspect the cable and the plug to make sure that neither are damaged. If any

damage is visible have the machine inspected/repaired by a suitably qualified person. If it is

necessary to replace the plug, it is preferable to use an 'unbreakable' type that will resist

damage. Only use a 13 Amp plug, make sure the cable clamp is tightened securely. Fuse at 13

Amp. If extension leads are to be used, carry out the same safety checks on them, and ensure

that they are correctly rated to safely supply the current that is required for your machine. It is

also recommended that the power supply outlet is the switched type, and that the supply is

switched off whilst plugging in, or unplugging the machine.

Good Working Practices/Safety

The following suggestions will enable you to observe good working practices, keep yourself and fellow

workers safe and maintain your tools and equipment in good working order.

WARNING!! KEEP TOOLS AND EQUIPMENT OUT OF THE REACH OF YOUNG CHILDREN

Work Place/Environment

The machine is not designed for working outside, do not use when or where it is liable to get wet. If the

machine does get wet; dry it off as soon as possible, with a cloth or paper towel. Do not use 240Va.c.

powered machines anywhere within a site area that is flooded or puddled, and do not trail extension cables

across wet areas. Keep the machines clean; it will enable you to more easily see any damage that may

have occurred. Clean the machine with a damp soapy cloth if needs be, do not use any solvents or

cleaners, as these may cause damage to any plastic parts or to the electrical components.