Axminster AWDTJ Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Alat Listrik Axminster AWDTJ. Axminster AWDTJ 6 halaman. 12" dovetail jig

5. Assembling Timber into the Jig

Adjust the top and front clamp bars via the hand screws at either end of each bar so that the

wood is held firmly in place when the cam clamp handles are operated. When narrower pieces of

timber are being worked it is best to use a packing piece of the same thickness at the opposite

end of the clamp bar to ensure an even grip and to avoid distorting the bars. Align the timber so

that the piece forming one of the sides of the drawer, mounted in the front vertical clamp, extends

above the front edge of the jig by the thickness of the piece to be mounted in the top horizontal

clamp (front or back of drawer). The piece in the top clamp is then butted up to this so that both

are flush under the finger guide (see Fig 6).

Fig 6

A X M I N S T E R

W H I T E

Start by temporarily removing the front clamp bar from the jig. Now draw a pencil line across the

template, halfway across the first finger and square to the edges of the template.(see Fig 3).

Set the top left hand stop in line with the line marked on the template and square to the body of

the jig.

Offset the left hand vertical stop 1/2" to the right of the top one and square with the top face of

the jig (Fig 4).

Mirror these two settings on the right hand side of the jig, ensuring that 90˚ alignment to the front

edge of the jig is maintained.

Left Hand Stop

3. Setting the End Stops

Fig 3