Axminster ZQJ4125K Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Alat Listrik Axminster ZQJ4125K. Axminster ZQJ4125K 18 halaman.

alignment of moving parts, breakage of parts , mounting and any other condition that

may affect its operation . A guard or other part that is damaged should be properly

repaired or replaced by an authorised service centre unless otherwise indicated in this

instruction manual .Have defective switches replaced by an authorised service center.

Do not use tool if switch does not turn it on and off.

21.

Warning: the use of any accessory or attachment other than an recommended in this

instruction manual may present a risk of personal injury.

22.

Have your tool repaired by a qualified person. This electric tool comlies with the

relevant safety rules. Repairs should only be carried out by qualified persons using

original spare parts, otherwise this may result in considerable danger to the user.

23.

Save these instructions.

Additional Safety Instructions For Drill Presses

1. ALWAYS OPERATE YOUR DRILL PRESS AT SPEEDS that are appropriate for the

drill bit size and the material that you are drilling.

2. FEED THE DRILL BIT EVENLY INTO THE WORKPIECE. Back the bit out of deep

holes and clear the chips with a brush after you have turned the machine off.

3. MAKE SURE THE DRILL BIT YOU ARE USING IS TIGHTENED PROPERLY. Use

only round, hex or triangular shank drill bits.

4. NEVER DO MAINTENANCE OR CHANGE SPEEDS WITH THIS MACHINE

PLUGGED IN.

5. NEVER USE TOOLS THAT ARE IN POOR CONDITION. Cutting tools that are dull or

damaged are difficult to control and may cause serious injury.

6. NEVER DRILL SHEET METAL UNLESS IT IS CLAMPED SECURELY TO THE

TABLE.

7. WORK SHOULD BE POSITIONED IN SUCH A WAY AS TO AVOID DRILLING INTO

THE TABLE.

8. A FACE SHIELD USED WITH SAFETY GLASSES IS RECOMMENDED.

9. ALWAYS CLAMP WORKPIECE SECURELY TO TABLE BEFORE DRILLING. Never

hold a workpiece by hand while drilling.

10. IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES performing the intended

operation, stop using the machine! Then contact our service department or ask a

qualified expert how the operation should be performed.

11. REMOVE ADJUSTING KEYS AND WRENCHES. Before turning the machine on,

make it a habit to check that all adjusting keys and wrenches have been removed.

12. HABITS—GOOD AND BAD—ARE HARD TO BREAK. Develop good habits in your

shop and safety will become second-nature to you.

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建

DRILL PRESS MANUAL