Axminster Trade 106005 Manual Petunjuk Asli - Halaman 4

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Sander Axminster Trade 106005. Axminster Trade 106005 16 halaman. Oscillating sander

1. Learn the machine's applications and limitations, as well as the specific potential hazards

particular to this machine. Follow available safety instructions and safety rules carefully.

2. Keep working area clean and be sure adequate lighting is available.

3. Do not wear loose clothing, gloves, bracelets, necklaces, or ornament. Wear face, eye, ear,

respiratory and body protection devices, as indicated for the operation or environment.

4. Keep hands well away from cutter head and all moving parts. Do not clear chips and

sawdust away with hands. Use a brush.

5. Make sure the spindles are moving at operation speed before sanding.

6. Do not push the sanding spindles to hard. The spindles will perform better and be safer

working at the rate for which it was designed.

7. Whenever possible use a dust collector with shaving hood to minimize health hazards.

8. Never leave the machine with the power on.

9. Keep children away. Make sure that visitors are kept at a safe distance from the work area.

10. Use recommended speed sanding accessory, and workpiece material.

11. Never stand on tool. Serious injury could occur if the tool is tipped or if the sanding tool is

unintentionally contacted.

12. Be sure sanding spindles are securely locked in the machine.

13. Use suitable support if stock does not have a flat surface.

14. Keep guards in place and in working order. If a guard must be removed for maintenance or

cleaning make sure it is properly attached before using the tool again.

15. Be sure that key and adjusting wrenches have been removed before turning power on.

16. Only use accessories designed for the machine. Use of accessories not recommended by

may result in a risk of injury.

17. Make sure tool is properly grounded. If tool is equipped with three-prong plug, it should be

plugged into a three-pole electrical receptacle. Never remove the third prong.

18. Always disconnect tool before servicing and when changing accessories such as spindle

sizes.

19. To make sure the cover of the magnetic switch has covered up before the machine

electrified.

20. Hold material firmly against the table.

21. Do not use this spindle sander for other than it's intended use. If used for other purposes,

disclaims any real or implied warranty and holds itself harmless for any injury, which may

result from that use.

SAFETY RULES

Read carefully before operating the machine