AccuMed AP212 Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Kebugaran AccuMed AP212. AccuMed AP212 15 halaman. Mini electronic pulse stimulator

TROUBLESHOOTING:

If your device is not operating properly, please check below for common problems and suggested solutions:
1.
No power source; no display in LCD:
Check if the battery is low and needs to be recharged.
If the unit was previously used, switch the power to OFF first, then back to ON.
2.
Stimulation is weak or nonexistent:
Check that the electrode pads are firmly attached to skin.
Check that the electrode pads are not touching each other.
Check that electrode pad are not stacked together or overlap.
Check that the cord is properly connected to the unit.
Check if the battery is low and needs to be recharged.
The intensity level is very low.
Both pads from the same wire must be attached to one person's body to feel sensation.
3.
Electrode pads are not sticky:
The electrode pads lost their adhesiveness and need to be replaced.
Wash adhesive surface of pads softly with your fingertips for about 3 seconds under slow running water.
Make sure you are not perspiring and are in a cool room when using.
If electrode pads were applied immediately after washing, make sure to dry the pad before applying.
If the electrode pads were exposed to high temperature, high humidity, or direct sunlight, the electrode pads may have
been ruined.
4.
The skin turns red or the skin feels irritated:
The therapy time is too long or the intensity is set too high.
The adhesive surface of pads is dirty or dry and must be washed.
If problem persists, stop using device and contact your physician.
5.
One pad feels stronger than the other:
This is normal. Different areas of your body will react differently.
Make sure the pads are sticky and are making good contact.
6.
Power cut off during use:
Check if battery is low and charge if necessary.
Check that cord is intact and is not broken.
10